LIBERTY 2004
WIRE	COLORS	LOCATION
12 VOLTS CONSTANT	RED & PINK/BLACK	IGNITION SWITCH HARNESS
IGNITION 1	RED/DARK BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER	BLACK/WHITE (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
PARKING LIGHTS (+)	DO NOT USE !!	@ BLACK Plug, Back of FUSE BOX in the top left corner
PARKING LIGHTS (-)	LIGHT GREEN/ORANGE (-)	@ HEADLIGHT SWITCH or BCM, GREY 22 Pin Plug Pin 5 See NOTE *3 *SEE DIAGRAM*
DOOR TRIGGER	See NOTE *2	@ BCM, See NOTE *3
DOME LIGHT	TAN (-)	@ BCM, See NOTE *3
POWER DOOR LOCK	PINK/PURPLE	@ REAR of FUSE BOX, TOP LEFT Plug Pin 14
POWER DOOR UNLOCK	1-Wire System same wire	*SEE DIAGRAM*
TRUNK RELEASE	ORANGE/PINK (-)	@ BCM, GREY 26 Pin plug Pin 17 See NOTE *3
TACH SENSOR	any wire NOT GREEN/ORANGE or ORANGE/GREEN at	any IGNITION COIL or FUEL-INJECTOR
BRAKE	WHITE/TAN(+)	@ SWITCH ABOVE BRAKE
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
FACTORY DISARM	LIGHT GREEN/ORANGE (-) See NOTE *4	@ BCM, Connector 2, Pin 9 *SEE DIAGRAM*

NOTE *1 the PARKING LIGHTS turn on with a (-) Negative thru a 1000 Ohm resistor See DIAGRAM

NOTE *2 the DRIVERS DOOR Trigger is a TAN (-) and the PASSENGER DOOR Trigger is a TAN/WHITE (-) when connecting to an Alarm System use both and Diode isolate.

NOTE *3 the BCM is attached to the LEFT of the FUSE BOX, Connector 1 is a GREY 26 Pin plug, and Connector 2 is a GREY 22 Pin plug.

NOTE *4 the Resistance value of this Resistor to Disarm can be a Standard 470 or 480 Ohm resistor.