Here is the wiring info for your car. If you have any other questions just ask. ITEM | WIRE COLOR |POL| WIRE LOCATION | | 12V|pink/black & red |+ |ignition harness | | STARTER|yellow |+ |ignition harness | | IGNITION|blue |+ |ignition harness | | SECOND IGNITION|green/red (20awg) |+ |ignition harness | | ACCESSORY|black/orange |+ |ignition harness | | SECOND ACCESSORY|black/white |+ |ignition harness | | POWER LOCK|white/green |*1 |conn. C4, pin 15 @ BCM *2 | | POWER UNLOCK|same |*1 |same | | LOCK MOTOR|orange/black | |conn. C4, pin 9 @ BCM *2 | | UNLOCK MOTOR|blue/white | |conn. C4, pin 13 @ BCM *2 | | DISARM DEFEAT|pink/lt. blue | |conn. C4, pin 25 @ BCM *2 | | PARKING LIGHTS +|black/yellow | |headlight switch or DKP | | HEADLIGHTS|purple/white |+ |headlight switch | | DOOR TRIGGER|*3 |- |BCM *2 | | DOME SUPERVISION|use door trigger | | | | TRUNK/HATCH PIN|tan/black |- |conn. C4, pin 18 @ BCM *2 | |TRNK/HTCH RELEASE|black/white |5wi|conn. C4, pin 1 @ BCM *2 | | FCTRY ALARM ARM|lt. green/orange |*4 |conn. C4, pin 4 @ BCM *2 | |FCTRY ALRM DISARM|same |*4 |same | | TACHOMETER|*5 | |*5 | | SPEED SENSE|white/orange |8 |conn. C2, pin 66 @ PCM *6 | | BRAKE WIRE|white/tan |+ |brake pedal switch | | HORN TRIGGER|black/red |- |steering column | | WIPERS|brn/wht, red/yel |+ |wiper motor | | LF WINDOW UP/DN|lt. blue - white |A |drivers window switch | | RF WINDOW UP/DN|brn/wht - pur/wht |A |drivers kick panel | | LR WINDOW UP/DN|blu/wht - red/blk |A |drivers kick panel | | RR WINDOW UP/DN|gry/blk - grn/wht |A |drivers kick panel | | SUN RF OPN/CLOSE|not recommended | | | | RADIO 12V|pink |+ |radio | | RADIO GROUND| | | | | RADIO SWITCH|red/white |+ |radio | | RADIO ILLUMINATE|orange/brown |+ |radio | | LF SPEAKER|green - brn/red | |radio | | RF SPEAKER|purple - blu/red | |radio | | LR SPEAKER|brn/yel - brn/lt blu| |radio | | RR SPEAKER|blu/wht - blu/org | |radio | Notes: NOTE: Chrysler vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting. Use DEI part number 555C or 555U. *1 Lock is positive thru a 1800 ohm resistor, unlock is positive thru a 750 ohm resistor. Must use relays. *2 The BCM is attached to the fuse/relay box at the end of the dash on the driver side. Connector C4 is a 26 pin plug on the bottom edge of the BCM. *3 All the door triggers are in connector C4 at the BCM. The drivers door trigger is tan in pin 5, the front passenger door is tan/red in pin 6, the left rear door is tan/orange in pin 7, and the right rear door is tan/yellow in pin 8. Use all four and diode isolate each. *4 Arm is positive trigger thru a 1800 ohm resistor, disarm is positive thru a 750 ohm resistor. Must use relays. *5 For tach go to either a coil or an injector and use the wire that is NOT green/lt. green. *6 The PCM is between the air filter box and the power distribution box on the driver side of the engine compartment. |