|
|
the12volt's install bay
Mobile Electronics Forums |
|
Welcome Guest :) |
|
|
 Topic: 2003 PT Cruiser Remote Start Wiring ( Topic Closed)
|
  |
|
| Author |
|
|
acherman
Joined: July 08, 2003
Location:
Canada
Posts: 12 |
| Posted: January 04, 2007 at 6:21 PM - IP Logged |
|
|
Hey everyone, I've been searching through and reading a number of posts on the PT Cruiser. I was only able to find a few details on the 01-02 PT. Just curious if anyone has the remote start wiring for the 2003 or if it is the same as the 01-02 model years. Thanks in advance. Aaron |
|
| Back to Top |
 |
|
|
Hi Guest
Not a member?
Register
Already
a member?
Sign In
|
|
|
|
Twelvoltz
Joined: March 24, 2005
Location:
New Jersey,
United States
Posts: 2,352 |
| Posted: January 04, 2007 at 6:50 PM - IP Logged |
|
|
DEI lists:
DIRECTWIRE™ WIRING INFORMATION - CHRYSLER / PT CRUISER / 2003 / Remote Start
[PRINT THIS PAGE]
12volts pink/black & red + ignition harness
Starter yellow + ignition harness
Second Starter N/A
Ignition blue + ignition harness
Second Ignition N/A
Third Ignition N/A
Accessory black/orange + ignition harness
Second Accessory black/white + ignition harness
Keysense lt. blue - ignition harness
Power Lock white/green - driver kick, door harness
Notes: Lock/arm requires a negative trigger thru a 3K (3000) ohm resistor. Unlock/disarm requires a negative trigger thru a 7.2K (7200) ohm resistor. Unlock requires a double pulse. MUST use relays.
Also found at the keyless entry module located above the radio in the center of the dash.
Can also use Directed 457C or 456L interface modules.
Power Unlock same wire as power lock
Lock Motor orange/black 5wi driver kick, door harness
Notes: Also found at the keyless entry module located above the radio in the center of the dash.
Unlock Motor pink/black 5wi driver kick, door harness
Notes: Also found at the keyless entry module located above the radio in the center of the dash.
Parking Lights+ black/yellow + headlight switch
Notes: Also found at the keyless entry module located above the radio in the center of the dash.
Parking Lights- N/A
Hazards same as turn signals
Turn Signal(L) lt. grn (F), dk. grn/red (R) + steering column
Turn Signal(R) tan (F), brown/red (R) + steering column
Reverse Light purple/black +
Door Trigger -
Notes: The tan or tan/blue wire catches the driver door and is found in the driver kick panel. The blue/orange catches the three passenger doors and is found in the passenger kick panel. Use both wires and diode isolate each.
Also found at the keyless entry module located above the radio in the center of the dash.
Dome Supervision use door trigger
Trunk/Hatch Pin tan/black - driver kick, harness to rear
Notes: Also found at the keyless entry module located above the radio in the center of the dash.
Hood Pin brown/tan - hood pin switch
Notes: Also found at the keyless entry module located above the radio in the center of the dash.
Trunk/Hatch Release N/A
Power Sliding Door N/A
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock single pulse the unlock wire
Tachometer black/gray ac ignition coil
Wait to start N/A
Brake Wire white/tan + brake pedal switch
Parking Brake gray/black - parking brake switch
Horn Trigger black/red - steering column
Memory Seat 1 N/A
Memory Seat 2 N/A
Memory Seat 3 N/A
Interface Module: Category:
Immobilizer Bypass Required:
Yes Type:
Sentry Key
Part #: 555CW
Alternate Part1 #: 556UW
Alternate Part2 #: DesignTech 20402
Alternate Part3 #: DesignTech 29402
Notes: Only vehicles with gray keys have the immobilizer.
Interface Module: Category:
Door Lock Interface Required:
Yes Type:
Data Bus
Part #: 457CW
Alternate Part1 #: 456LW
Notes:
Smart Starter Kill Relays: Not Available
warning
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
|
|
| Back to Top |
|
|
|
acherman
Joined: July 08, 2003
Location:
Canada
Posts: 12 |
| Posted: January 04, 2007 at 6:53 PM - IP Logged |
|
|
Excellent. Thank you so much!!! Aaron |
|
| Back to Top |
|
|
|
|
Sorry, you can NOT post a reply.
This topic is closed.
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
| |
Member List
Search
Register
Login
