HI, im new to this site. I couldnt find it in the search. I need the wiring diagram for a Ford 2006 F-250 6.0l Diesel truck for a alarm w/ remote start install... If any one could help i would appreicate it.

Thanks

This is NOT an easy truck.....

PASSIVE ANTI-THEFT	YES	TRANSPONDER	SEE NOTES
12 VOLTS	Yellow	Ignition harness	+
IGNITION	Red/green	Ignition harness	+
IGNITION 2	Blue/green
This wire is only required on the V-10 Gas engine.
ACCESSORY	Red/black	Ignition harness	+
ACCESSORY 2	Gray/yellow	Ignition harness	+
STARTER	Dk.green	Ignition harness	+
KEY SENSE	Black/pink	In airbag plug on right side of st. column	-
TACH SIGNAL	Use an injector
DIESEL TACH SIGNAL	Green/white	SEE NOTES
Look below the relay box under the dash for a large loomed harness. There are some wires taped to the harness terminated with heat shrink tubing. You will find the green/white among these wires.
LOCK	White/red	In harness above gas pedal	+
On 4 door models, these wire are negative trigger. Vehicles with no keyless entry, colors are Pink/yellow for lock and Pink/green for unlock in 5-wire reverse polarity. They will be found in either kickpanel.
UNLOCK	Black/white	In harness above gas pedal	+
On 4 door models, these wire are negative trigger. Vehicles with no keyless entry, colors are Pink/yellow for lock and Pink/green for unlock in 5-wire reverse polarity. They will be found in either kickpanel.
DRIVER LOCK MOTOR	Pink/black	In harness above gas pedal	+
DRIVER UNLOCK MOTOR	Red/orange	In harness above gas pedal	+
PASSENGER UNLOCK MOTOR	Pink/orange	In harness above gas pedal	+
GLO-PLUG SIGNAL	DATA ONLY	USE DELAY TIMER
DOORPIN	Black/blue	Above parking brake in DKP	+
The vehicle’s computer sends out diagnostic pulses on this wire every 15-20 minutes. This may cause an after-market alarm to false. It is suggested that you add a relay to this wire when connecting to an alarm system. See the appropriate diagram for exact wiring instructions.
FACTORY ARM	Yellow/black	Above parking brake in DKP	-
This is the driver’s doorpin wire. Pulse this wire at the same time as lock to arm the factory alarm.
FACTORY DISARM	Dk.green/purple	In harness above gas pedal	-
BRAKESWITCH	Green	At switch above brake pedal	+
PARKLIGHTS	Brown	At light switch harness	+
HAND BRAKE	Lt.green/red	At plug above handbrake lever	-
HORN	Dk.blue	In airbag plug on right side of st. column	-

I agree they aren't that bad except for tach.  I had to do one and setup the thing for voltage sense and crank time.  It was something ridiculous, but it has factory anti grind so as soon as the truck starts, the starter won't crank.  It saved my life seeing as this truck was being shipped off overseas and I didn't have time to get a signal generator.