2003 suburban | ITEM | WIRE COLOR |POL| WIRE LOCATION | | 12V|red & red/white |+ |ignition harness | | STARTER|yellow |+ |ignition harness | | IGNITION|pink |+ |ignition harness | | SECOND IGNITION|white |+ |ignition harness | | ACCESSORY|orange |+ |ignition harness | | SECOND ACCESSORY|brown |+ |ignition harness | | POWER LOCK|use Directed module | | | | POWER UNLOCK|part #456G *3 | | | | LOCK MOTOR|gray | |driver door module in door | | UNLOCK MOTOR|tan | |driver door module in door | | DISARM DEFEAT|tan | |driver rear door harness | | PARKING LIGHTS +|brown | |driver kick panel | | PARKING LIGHTS -|gray/black | |headlight switch | | HEADLIGHTS|pink or white |- |headlight switch | | DOOR TRIGGER|*1 |- |*1 | | DOME SUPERVISION|comes on with disarm| | | | TRUNK/HATCH PIN|pink/black |- |harness to BCM *2 | | HOOD PIN| | | | |TRNK/HTCH RELEASE| | | | | FCTRY ALARM ARM| | | | |FCTRY ALRM DISARM|lt. green |- |driver door module in door | | TACHOMETER|NOT pink | |any fuel injector | | SPEED SENSE| | | | | BRAKE WIRE|white |+ |brake pedal switch | | HORN TRIGGER|black or blk/yel |- |column or gray plug @ BCM *2| | WIPERS| | | | | LF WINDOW UP/DN|blue - brown |A |LF window switch in door | | RF WINDOW UP/DN|lt. blue - tan |A |RF window switch in door | | LR WINDOW UP/DN|blue - brown |A |LR window switch in door | | RR WINDOW UP/DN|blue - brown |A |RR window switch in door | | SUN RF OPN/CLOSE| | | | | SUN ROOF LIMIT| | | | | RADIO 12V| | | | | RADIO GROUND| | | | | RADIO SWITCH| | | | | RADIO ILLUMINATE| | | | | POWER ANTENNA| | | | | LF SPEAKER| | | | | RF SPEAKER| | | | | LR SPEAKER| | | | | RR SPEAKER| | | | Notes: NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. Use DEI part 555t or 555L. *1 The driver door trigger is gray/black at the driver door module in the door. The RF door trigger is black/white at the passenger door module in the door. The LR door trigger is lt. blue/black and the RR is lt. green/black, they are in a harness in front of the fusebox leading to the BCM rear plug. Use all four wires and diode isolate each. *2 The BCM (Body Control Module) is located behind the headlight switch. *3 If Directed module part #456G is not available, refer to directfax document #1601. Upper trim level vehicles may have a door lock switch on the right rear panel. If present use white (-) for lock and lt. blue (-) for unlock. 2002 dodge ram | ITEM | WIRE COLOR |POL| WIRE LOCATION | | 12V|pnk/blk & red/wht |+ |ignition harness | | STARTER|yellow |+ |ignition harness | | IGNITION|blue (16 awg) |+ |ignition harness | | SECOND IGNITION|red or red/wht |+ |ignition harness | | ACCESSORY|green & orange |+ |ignition harness | | SECOND ACCESSORY|blue & blk/wht *7 |+ |ignition harness | | POWER LOCK|white/green *1 |- |driver kick panel | | POWER UNLOCK|same wire | | | | LOCK MOTOR|tan/pnk or tan/blk | |driver kick panel | | UNLOCK MOTOR|blue | |driver kick panel | | DISARM DEFEAT|tan/white | |passenger kick panel | | PARKING LIGHTS +|black/yellow | |relay under hood at pwr ctr | | PARKING LIGHTS -|purple/yellow *2 | |headlight switch | | HEADLIGHTS|purple/yellow *2 |- |headlight switch | | DOOR TRIGGER|*3 |- |*3 | | DOME SUPERVISION|use door trigger | | | | FCTRY ALARM ARM|lt green/orange *4 |- |driver kick panel | |FCTRY ALRM DISARM|same wire | | | | DISARM NO UNLOCK|same wire | | | | TACHOMETER|NOT green/orange | |ign coil, coil pac, injector| | SPEED SENSE|white/orange | |wht conn. 2, pin 27 @ PCM *5| | BRAKE WIRE|white/tan |+ |brake pedal switch | | HORN TRIGGER|black/red |- |steering column | | WIPERS|brn/wht(L),rd/yel(H)|+ |wiper motor | | LF WINDOW UP/DN|lt blue - white |A |driver window switch | | RF WINDOW UP/DN|brn/wht - pur/wht |A |driver kick panel | | LR WINDOW UP/DN|red/blk - blu/wht |A |driver kick panel | | RR WINDOW UP/DN|grn/wht - gry/blk |A |driver kick panel | | RADIO 12V|pink |+ |radio | | RADIO GROUND|black/green |- |radio | | RADIO SWITCH|brown/red |+ |radio | | RADIO ILLUMINATE|orange/blue (dimmer)|+ |radio | | LF SPEAKER|lt grn/rd-lt grn/grn| |radio or amplifier *6 | | RF SPEAKER|lt blu/pu-lt blu/blk| |radio or amplifier *6 | | LR SPEAKER|wht/red - wht/blk | |radio or amplifier *6 | | RR SPEAKER|tan/pur - tan/blk | |radio or amplifier *6 | Notes: NOTE: For the 2002 Ram 2500/3500, refer to the 2001 techsoft sheet. NOTE: Chrysler vehicles that use a gray ignition key have an immobilizer system that needs to be bypassed when remote starting. Use DEI part number 555C or 555U. *1 Lock requires a negative trigger thru a 820 ohm resistor. Unlock requires a negative trigger thru a 330 ohm resistor. MUST use relays. *2 Parking lights require a negative trigger thru a 330 or 1.4K ohm resistor. Headlights require a negative trigger thru a 1.8K ohm resistor. There is a rest resistance on the wire, so MUST use a relay to isolate away from the switch. *3 The LF door trigger is tan, and the LR door is tan/orange or purple/orange. These wires are in the driver kick panel. The RF door trigger is tan/red, and the RR door is tan/yellow. These wires are in the passenger kick panel. Use all wires and diode isolate each. See directfax document #1076 for wiring information. *4 This will also do door locks. Arm/lock is negative trigger thru a 2K ohm resistor. Disarm/unlock is negative trigger thru a 480 ohm resistor. Single pulse will do disarm without unlocking the doors. Unlock requires a double pulse. MUST use relays. *5 The PCM (Powertrain Control Module) is on the passenger side firewall. *6 The amplifier is located behind the glove box. *7 These wires may not be necessary for remote start. ___________________________________ Luis
Sound Waves
Is up to the installer to test all wires with a DMM whenever possible. |