
|
 |
the12volt's install bay Mobile Electronics Forums |
|
Welcome Guest :) |
|
|
Topic: 2007 sebring sedan, remote start, alarm ( Topic Closed)
|
  |
 |
| Author |
|
|
1000toni Joined: July 09, 2005 Posts: 14 |
| Posted: August 23, 2007 at 5:15 PM - IP Logged |
|
|
Anyone have the wiring color diagrams for a 2007 sebring , need to install a remote starter & alarm.
Thank you! |
|
| Back to Top |
 |
 |
|
Hi Guest
Not a member?
Register
Already
a member?
Sign In
|
|
 |
|
ceasar326 Joined: February 02, 2006 Location: Minnesota, United States Posts: 233 |
| Posted: August 23, 2007 at 5:37 PM - IP Logged |
|
|
CHRYSLER / SEBRING SEDAN / 2007 / Remote Start
| 12volt | red/tan (10A) | + | ignition harness | | Starter | yel/pur (not for remote start) | + | driver fender | Notes: On the 4 cylinder models, it is in a 20 pin plug, pin 12.
On the 6 cylinder models, it is in a 14 pin plug, pin 6.
Also found at the TIPM, lt. gray 8 pin plug, pin 8.
The TIPM (Totally Integrated Power Module) is under the hood on the driver fender. | | Second Starter | purple/brown | - | ignition harness | | Notes: Starter is negative trigger thru a 180 ohm resistor. See DirectFax document 1084 for wiring information. | | Ignition | pink | + | ignition harness | | Second Ignition | N/A | | | | Third Ignition | N/A | | | | Accessory | same as second starter wire | | | | Notes: Accessory is negative trigger thru a 610 ohm resistor. See DirectFax document 1084 for wiring information. | | Second Accessory | N/A | | | | Keysense | same as second starter wire | | | | Notes: Key sense is negative trigger thru a 8500 ohm resistor. | | Power Lock | lt. grn/pur or lt. grn/dk. grn | - | DKP or cluster, brown plug, pin 18 | | Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays. | | Power Unlock | same as power lock wire | | | | Lock Motor | tan/dk. blue | 5wi | DKP or cluster, bk 10 pin plg, pin 9 | | Unlock Motor | tan/dk. green | 5wi | DKP or cluster, bk 10 pin plg, pin 5 | | Parking Lights+ | white/purple | + | driver kick, harness to rear | | Parking Lights- | (LIN data bus) | | | | Hazards | (LIN data bus) | | | | Turn Signal(L) | wht/lt. grn(F), wht/dk. grn(R) | + | light (F); dr kick, harn to rear (R) | | Turn Signal(R) | white/tan (F), white/yel (R) | + | light (F); dr kick, harn to rear (R) | | Reverse Light | white/lt. green | + | driver kick, harness to rear | | Door Trigger | see notes | - | each kick or cluster, brown plug | | Notes: The LF door is purple in pin 3. The RF door is purple/white in pin 11. The LR door is purple/gray in pin 5. The RR door is purple/yellow in pin 6. Use all four wires and diode isolate each. | | Dome Supervision | yellow/white | + | DKP or cluster, brown plug, pin 4 | | Notes: Also found in the passenger kick or in the passenger side A pillar. | | Trunk/Hatch Pin | purple/orange | - | DKP or cluster, brown plug, pin 13 | | Hood Pin | purple/lt. blue | - | hood pin switch under hood | | Trunk/Hatch Release | lt. green/white | - | sw or cluster, bk 20 pin plg, pin 13 | | Notes: The trunk release motor wire is tan/yellow (+) in the driver kick or at the cluster, black 10 pin plug, pin 4. | | Power Sliding Door | N/A | | | | Factory Alarm Arm | arms on lock with door open | | | | Factory Alarm Disarm | factory remote only | | | | Disarm No Unlock | with ign, keysense, Sentry Key | | | | Tachometer | NOT brown/dk. blu or brown/yel | ac | any ignition coil or fuel injector | | Wait to start | N/A | | | | Brake Wire | dk. green/white | + | switch or cluster, brown plug, pin 8 | | Parking Brake | dk. green/white | - | switch or cluster, brown plug, pin 7 | | Horn Trigger | dk. green/purple | - | sw or cluster, bk 20 pin plg, pin 10 | | Memory Seat 1 | N/A | | | | Memory Seat 2 | N/A | | | | Memory Seat 3 | N/A | | |
| Interface Module: | Category: Immobilizer Bypass | Required: Yes | Type: Sentry Key | | Part #: PKU-CH2X | | Alternate Part1 #: 556CW | | Alternate Part2 #: 556UW | | Alternate Part3 #: DesignTech 20402 | | Alternate Part4 #: DesignTech 29402 | | Notes: Standard on all models. | | Interface Module: | Category: Door Lock Interface | Required: No | Type: Data Bus | | Part #: XK03 | | Alternate Part1 #: 456LW | | Notes: | | Interface Module: | Category: Combo Interface | Required: No | Type: Data Bus | | Part #: XK532 | | Alternate Part1 #: IOM-Chrysler-7 | | Notes: When using the combo module it is not necessary to use doc 1084. That part takes care of 2nd starter and accessory, locks, and bypass. |
|
|
|
| Back to Top |
 |
 |
|
1000toni Joined: July 09, 2005 Posts: 14 |
| Posted: August 24, 2007 at 12:59 PM - IP Logged |
|
|
|
| Back to Top |
 |
 |
|
|
Sorry, you can NOT post a reply. This topic is closed.
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum
|
|
|
 |
|
|
| |