2007 acura tl remote starter issue

I installed a Remote Start into a 2007 Acura TL, I used the Viper 5901 along with Flash Logic FLCAN D2D. Everything was working fine until the car did not remote start anymore. Everything would turn on but it would not crank over. I reset the FLCAN and it worked fine. It happened again and I reset it again and it worked fine again for another couple weeks. This last time the issue occurred resetting the FLCAN did nothing. It would still turn on all the accessory components but not crank over. The FLCAN blinks properly as if everything is working fine when I hit the r/s button on the 5901. Everything that runs off the FLCAN (the door locks, triggers, trunk pop etc.) works fine. Does anyone have a solution? Thank You Very Much.

i had issues with the idatalink ADS-AL-CA loosing its programming for bypass, triggers, etc. This is was the 08 TL-S happened to me twice on a customers car, worked for a week, reprogrammed worked for 3 months. The third time i ended up reflashing/reprogramming the bypass and its been okay since then. which has been ~8months. Try reflashing if you canTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

btw, i suggest you switch it to w2w that way you can have an easier time doing diagnostics.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Yea its a TL-S 2007 ... funny thing is that all other functions work perfectly fine just it wont remote start .. i put the key in the ignition and turn it 2 clicks then hit the r/s and it works (it doesnt work with just the key in or on the first click) does this tell you anything? the pink wire on the r/s and the flcan are secure ... anyway i will reflash it thanks for the advice

that means an igniton circuit is not being powered up correctly.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert