the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Installation Time of an alarm


Post ReplyPost New Topic
< Prev Topic Next Topic >
meh66 
Copper - Posts: 266
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 26, 2003
Location: United States
Posted: November 24, 2003 at 11:34 AM / IP Logged  

Hello,

I was wondering what the average installation time is for a car alarm?

MEH66
"Car Performance and Mobile Electronic Enthusiats"
vaderfop 
Copper - Posts: 95
Copper spacespace
Joined: April 18, 2003
Location: United States
Posted: November 24, 2003 at 2:04 PM / IP Logged  
Depends on the car, if you are adding remote start, etc.
For instance, I have done a couple cars in under well under 2 hours for a basic car alarm. However, there have been time when I was doing everything (alarm/keyless/RS) and it has taken me about 12 hours. So it just really depends on what you are working with.
Also your times will start going down once you get very proficant at preping and installing. My first alarm took me awhile since I had never done one, now they dont ever take me any where near as long.
Remember check all your wires with a DMM!
meh66 
Copper - Posts: 266
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 26, 2003
Location: United States
Posted: November 24, 2003 at 2:31 PM / IP Logged  

  I just installed my first alarm with remote start and keyless entry . I took about ten hours to complete. Thanks for your input.

MEH66
"Car Performance and Mobile Electronic Enthusiats"
djfearny2 
Silver - Posts: 810
Silver spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: September 23, 2002
Location: United States
Posted: November 24, 2003 at 2:54 PM / IP Logged  
wow 12 and ten hours to complete a alarm. rs. or keyless or a system with all three is a long time but i guess the experience comes in to play i can do a dodge hemi diesel alarm remote start in under three hours,
dodge hemi bio
four seperate door triggers that need to be diode isolated. resistor parking light wire that also needs a relay to prevent feedback from the p light wire. and pne wire resistor door locks recently made easier from dei's new reistance module. this is not cutting short cuts either which means a tach and hood pin is installed as well.
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
draasch 
Gold - Posts: 2,172
Gold spacespace
Joined: February 07, 2003
Location: Florida, United States
Posted: November 24, 2003 at 3:26 PM / IP Logged  
yes you will get batter as time goes by...however you must stay up-to-date on the car info. if you use a good web site, then you will have all the info you need to do asafe,nice and neat install.
Remember: IF YOU DONT HAVE TIME TO DO IT RIGHT THE FIRST TIME, YOU WILL ALWAYS HAVE TIME TO DO IT AGAIN!
make time and do it right the first time. if you do it twice, you have now lost money.
good luck!
Good Luck
David
Ace Security
813-376-9778
Tampa
Donate to the 12volt
meh66 
Copper - Posts: 266
Copper spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: October 26, 2003
Location: United States
Posted: November 24, 2003 at 3:52 PM / IP Logged  
I should get faster, but I wanted to make sure my install was clean. I aslo had to work with an alarm that was previously installed in another car. Wire were all tangled up.
MEH66
"Car Performance and Mobile Electronic Enthusiats"
auex 
Platinum - Posts: 5,041
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: December 23, 2002
Location: Arizona, United States
Posted: November 24, 2003 at 9:55 PM / IP Logged  
It takes me less then an hour to do a basic alarm install with keyless, this is clean and looks factory. When training it will take me and the person that I train upto 3 hours. The longest alarm install that I have ever done was in an integra type R and took me around 9 hours, this was installing a viper 800esp, 4 siren's, hood pin, trunk pin, horn, 1 backup battery siren, 1 backup battery, front windows up and down, sunroof open and close, radar, glass brake sensor, 4 led's(2 in the doors and 2 in the rear deck), radio turn on, trunk pop solienoid, and a couple other misc extras. The alarm was under the driver's seat and everything looked as factory as possible.
Certified Security Specialist
Always check info with a digital multimeter.
I promise to be good.
Tell Darwin I sent you.
I've been sick lately, sorry I won't be on much.
tjdurham 
Copper - Posts: 180
Copper spacespace
Joined: July 25, 2003
Location: United States
Posted: November 24, 2003 at 11:52 PM / IP Logged  
most cars for a basic alarm should take no more than 2 hours add remote start to the system should only add 15-20 mins. unluss you have a factory alarm or transponder, now that there are so many data bypasses it makes sense to use them because of the time they save WE ALL KNOW WHAT TIME IS $$$$$
tj
sroth140 
Silver - Posts: 513
Silver spacespace
Joined: August 27, 2003
Location: United States
Posted: November 25, 2003 at 1:40 AM / IP Logged  

2 hours is about right.  remote start on to an alarm is only a few wires at the ignition harness and a tach wire.  you are already running the wire to the engine so you can get the tach then, and you are already at the ignition harness for most of the same wires as a remote start.  finding door triggers and lock wires can be tricky but that comes with experience.  i did a keyless/alarm/RS in a 1992 honda civic in 2hrs.  prewire, test all your wires, mount the brain (and relay pack if you have a unit still using one), run the wires nice and cut them toa decent length, solder + tape, then zip tie/tape it up for clenliness.

some cars are harder because of room or wire size or whatever, bu the basics still apply.

birdondubthreez 
Member - Posts: 21
Member spacespace
Joined: November 20, 2003
Location: United States
Posted: November 25, 2003 at 10:24 PM / IP Logged  
Sounds like a dick measuring contest to me.
BiRdOnDuBtHrReEz
Page of 2

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer