the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

2008 dodge nitro remote start/keyless


Post ReplyPost New Topic
< Prev Topic Next Topic >
last 
Member - Posts: 2
Member spacespace
Joined: July 31, 2007
Location: United States
Posted: November 09, 2007 at 10:53 PM / IP Logged  
I worked with this nitro tonight and could not find the lock/unlock wire for the life of me.... no violet/green GREEN/ violet anywhere driver or passenger door harnesses.
violet/orange looks like a data wire that would control them but toasted a fuse when i tried any signal. the normal 330 ohm lock and 1k unlock or the other way around.
Newest information i could find was 2007 guide, directechs didn't have 2008 info either.
anyone know anything that would have helped me?
mrjc480 
Member - Posts: 44
Member spacespace
Joined: December 16, 2004
Location: United States
Posted: November 10, 2007 at 12:02 AM / IP Logged  
I just did a 07 last weekend.  I grabbed the locks in the passenger door PURPLE / lt green through a 1k and a 180 ohm res.  This was a PITA.  I had to cut the front door triggers from the BCM and diode isolate them in addition from each other because they were being triggered 60 sec after locking/arming.
Im moving to MEXICO and Im not speaking spanish!
extreme1 
Silver - Posts: 1,070
Silver spacespace
Joined: February 12, 2003
Location: Canada
Posted: November 10, 2007 at 12:22 AM / IP Logged  
idatalink ads-al-ca will do keyless, alarm, door and trunk outputs as well as ign mux wiring, add an ads-rngc2 and you have your transponder bypass.
Shaughn Murley
Install Manager, Dealer Services
Visions Electronics
Red Deer, Alberta
last 
Member - Posts: 2
Member spacespace
Joined: July 31, 2007
Location: United States
Posted: November 10, 2007 at 11:24 AM / IP Logged  
the 08 didn't have the same color wire as the 07, went to both doors, the only wire that looks like it controls the locks is a violet/orange, theres a group of 3 wires, one ground i think white green, another white with a color and the violet orange in a connector on the lock/unlock button but resistance didn't seem to change when i tested it, leads me to believe they are data.
i think i need a door lock module. that idatalinkads-al-ca sounds like it would work.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, March 28, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer