the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

1987 Nissan Sentra diagram needed


Post ReplyPost New Topic
< Prev Topic Next Topic >
carnuck 
Member - Posts: 1
Member spacespace
Joined: May 28, 2004
Location: United States
Posted: May 28, 2004 at 3:03 PM / IP Logged  
The motor was changed and now the car won't start. I bypassed the inhibitor to get it to crank, but still don't have spark. Since this has a Electronically controlled carb (ECC) system, it's a lot more complicated than even most fuel injection systems (ie: The wires from the dist don't come close to the coloring at the ignition coil) I can find '86 and '88 factory manuals ($55 each used! OUCH!) but neither wiring diagram is the same. I checked the alarm wiring codes here, but that only gave me the tach coloring.
jfk51502003 
Copper - Posts: 221
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: May 28, 2004 at 3:54 PM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - NISSAN / SENTRA / 1987 / Remote Start
[PRINT THIS PAGE]
12volts BLACK/ red   +  ignition harness
Starter BLACK / YELLOW   +  ignition harness
Second Starter     
Ignition BLACK/ white   +  ignition harness
Second Ignition     
Third Ignition     
Accessory WHITE/ blue   +  ignition harness
Second Accessory     
Keysense     
Power Lock add actuator    all doors
Power Unlock add actuator    all doors
Lock Motor     
Unlock Motor     
Parking Lights+ GREEN/ black    steering column
Parking Lights-     
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger yellow/purple   -  either pin
Dome Supervision     
Trunk/Hatch Pin RED / yel, RED / black   -  at switch, at light
Hood Pin     
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm     
Factory Alarm Disarm     
Disarm No Unlock     
Tachometer BLACK/ red, RED / white  AC  coil, ECM or cluster
Wait to start     
Brake Wire lt. GREEN/ red   +  at brake pedal switch
Parking Brake     
Horn Trigger GREEN/ black   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
1987 Nissan Sentra diagram needed -- posted image.
Immobilizer Bypass Module:Required: NoType: N/APart #: N/A
Notes: N/A
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
jfk51502003 
Copper - Posts: 221
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: May 28, 2004 at 3:54 PM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - NISSAN / SENTRA / 1987 / Remote Start
[PRINT THIS PAGE]
12volts BLACK/ red   +  ignition harness
Starter BLACK / YELLOW   +  ignition harness
Second Starter     
Ignition BLACK/ white   +  ignition harness
Second Ignition     
Third Ignition     
Accessory WHITE/ blue   +  ignition harness
Second Accessory     
Keysense     
Power Lock add actuator    all doors
Power Unlock add actuator    all doors
Lock Motor     
Unlock Motor     
Parking Lights+ GREEN/ black    steering column
Parking Lights-     
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger yellow/purple   -  either pin
Dome Supervision     
Trunk/Hatch Pin RED / yel, RED / black   -  at switch, at light
Hood Pin     
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm     
Factory Alarm Disarm     
Disarm No Unlock     
Tachometer BLACK/ red, RED / white  AC  coil, ECM or cluster
Wait to start     
Brake Wire lt. GREEN/ red   +  at brake pedal switch
Parking Brake     
Horn Trigger GREEN/ black   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
1987 Nissan Sentra diagram needed -- posted image.
Immobilizer Bypass Module:Required: NoType: N/APart #: N/A
Notes: N/A
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
jfk51502003 
Copper - Posts: 221
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: May 28, 2004 at 3:55 PM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - NISSAN / SENTRA / 1987 / Remote Start
[PRINT THIS PAGE]
12volts BLACK/ red   +  ignition harness
Starter BLACK / YELLOW   +  ignition harness
Second Starter     
Ignition BLACK/ white   +  ignition harness
Second Ignition     
Third Ignition     
Accessory WHITE/ blue   +  ignition harness
Second Accessory     
Keysense     
Power Lock add actuator    all doors
Power Unlock add actuator    all doors
Lock Motor     
Unlock Motor     
Parking Lights+ GREEN/ black    steering column
Parking Lights-     
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger yellow/purple   -  either pin
Dome Supervision     
Trunk/Hatch Pin RED / yel, RED / black   -  at switch, at light
Hood Pin     
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm     
Factory Alarm Disarm     
Disarm No Unlock     
Tachometer BLACK/ red, RED / white  AC  coil, ECM or cluster
Wait to start     
Brake Wire lt. GREEN/ red   +  at brake pedal switch
Parking Brake     
Horn Trigger GREEN/ black   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
1987 Nissan Sentra diagram needed -- posted image.
Immobilizer Bypass Module:Required: NoType: N/APart #: N/A
Notes: N/A
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
jfk51502003 
Copper - Posts: 221
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: May 28, 2004 at 4:06 PM / IP Logged  
DIRECTWIRE™ WIRING INFORMATION - NISSAN / SENTRA / 1987 / Remote Start
[PRINT THIS PAGE]
12volts BLACK/ red   +  ignition harness
Starter BLACK / YELLOW   +  ignition harness
Second Starter     
Ignition BLACK/ white   +  ignition harness
Second Ignition     
Third Ignition     
Accessory WHITE/ blue   +  ignition harness
Second Accessory     
Keysense     
Power Lock add actuator    all doors
Power Unlock add actuator    all doors
Lock Motor     
Unlock Motor     
Parking Lights+ GREEN/ black    steering column
Parking Lights-     
Hazards     
Turn Signal(L)     
Turn Signal(R)     
Reverse Light     
Door Trigger yellow/purple   -  either pin
Dome Supervision     
Trunk/Hatch Pin RED / yel, RED / black   -  at switch, at light
Hood Pin     
Trunk/Hatch Release     
Power Sliding Door     
Factory Alarm Arm     
Factory Alarm Disarm     
Disarm No Unlock     
Tachometer BLACK/ red, RED / white  AC  coil, ECM or cluster
Wait to start     
Brake Wire lt. GREEN/ red   +  at brake pedal switch
Parking Brake     
Horn Trigger GREEN/ black   -  steering column
Memory Seat 1     
Memory Seat 2     
Memory Seat 3     
1987 Nissan Sentra diagram needed -- posted image.
Immobilizer Bypass Module:Required: NoType: N/APart #: N/A
Notes: N/A
      
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, April 16, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer