Print Page | Close Window

First: Sound deadener or Fiberglass?

Printed From: the12volt.com
Forum Name: General Discussion
Forum Discription: General Mobile Electronics Questions and Answers
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=13279
Printed Date: May 25, 2024 at 7:57 AM


Topic: First: Sound deadener or Fiberglass?

Posted By: integration20
Subject: First: Sound deadener or Fiberglass?
Date Posted: May 07, 2003 at 3:56 PM

I was curious wich do you prefer first? I will be making kick panels for my car in the next couple of weeks and also making a fiberglass amp container in my trunk(Not in the spare tire well but there is a small compartment connected to it that fits both of my amps and want to put them in there and run fans to keep them cool) I've never done either before, so I wasn't sure which I should do first. I was thinking of "dynamatting" first but I want to do the trunk and the car doors atleast, so I wasn't sure if I should "dynamat" before or after the fiberglass. I doubt I will be "dynamatting" my whole floor where the seats are. Thanks inadvance!

:Cliffnotes: Want to dynamat my trunk and doors but want to make a fiberglass compartment for my amps near the spare tire well and not sure which to do first because I dont' want one to cause installation problems to the other.



-------------
Integration20



Replies:

Posted By: bberman1
Date Posted: May 07, 2003 at 7:08 PM
to make it short you always dynamat first and fiberglass 2nd



Posted By: Big Purds
Date Posted: May 08, 2003 at 3:14 PM
you Dynamat (Brown Bread for me) first because you want to deaden the vehicle itself, and dynamatting the fibreglass doesnt do anything for the resonance of the car itself...



Posted By: integration20
Date Posted: May 08, 2003 at 3:43 PM
Thanks a lot!

-------------
Integration20



Posted By: bberman1
Date Posted: May 08, 2003 at 5:04 PM

not a problem





Print Page | Close Window