I just ordered a crime stopper cs-2011rsII. I have installed alarms in the past but never with a remote start. Is there anything I need to know before I start installing it, any surprises? I like to know as much as I can before I start. I have read in the past that there has been a problems with the door locks and the heater working correctly. I do have a question about the relays, does the crime stopper come with all the relays that I need or do I need to go out and buy them when I in the middle of installing it.
Thanks
John
Email me and I can help you . I have a Caravan with a 2011 in it - Brian
finnman925@hotmail.com
Here is some information if finnman925 did not help you out already:
| ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|red |+ |ignition harness |
| STARTER|yellow |+ |ignition harness |
| IGNITION|blue |+ |ignition harness |
| SECOND IGNITION|BLACK/ orange |+ |ignition harness |
| ACCESSORY|BLACK/ white *1 |+ |ignition harness |
| POWER LOCK|WHITE/ green |*2 |left plug at bottom of fuse |
| POWER UNLOCK|same wire |*2 |box under cover (1 of 3) |
| LOCK MOTOR|brown | |*3 |
| UNLOCK MOTOR|BLACK/ pink | |*3 |
| DISARM DEFEAT|violet/white | |*3 |
| PARKING LIGHTS +|do NOT use | | |
| PARKING LIGHTS -|grn/wht or grn/red | |at light switch *4 |
| HEADLIGHTS|lt. GREEN/ orange |- |at light switch |
| DOOR TRIGGER|BROWN / lt. green |- |dome light on/off switch |
| DOME SUPERVISION|BROWN / white |- |dome light on/off switch |
| TRUNK/HATCH PIN|tied in with doors | | |
| HOOD PIN|pink/black |- |underhood light |
| FCTRY ALARM ARM|arms with lock | | |
|FCTRY ALRM DISARM|disarms with unlock | | |
| DISARM NO UNLOCK|see directfax #1081 | | |
| TACHOMETER|gray or gray/red | |ignition coil |
| BRAKE WIRE|WHITE/ tan |+ |brake switch |
| HORN TRIGGER|gray/orange |- |top right plug of fuse box |
| WIPERS|pink/purple |- |steering column |
| LF WINDOW UP/DN|lt. green - white |A |drivers door switch |
| RF WINDOW UP/DN|brown - purple |A |drivers kick panel |
| LR WINDOW UP/DN|dk. blue - red |A |drivers kick panel |
| RR WINDOW UP/DN|gray - dk. green |A |drivers kick panel |
Notes:
*1 Not required for remote start. *2 Use relays and set up for negative trigger. Place a 4020 ohm resistor inline on the lock output, and a 665 ohm resistor inline on the unlock output. If you do not have a factory security system use a 1500 ohm for lock and a 250 ohm for unlock. *3 The door lock motor wires are located in the top left plug at the relay/fuse box under the drivers side of the dash. *4 If the van has auto lamps, see direct fax document #1080.
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA