Where do I run the wires to get to the battery, pinswitch and siren? I do not see any empty gromets. Do I have to drill my own hole, if so any ideas where is a good place to dill (safe).
I was looking above the gas pedal that might be a good spot.
Thanks
John
yes more than likely you would have to drill a whole buy a unibit from hardware store or home depot its 15 bucks about. but in this car i am not sure that you have to run a constant wire to the battery you can just tapp off the ignition harness. make sure the wire you tapp of shows 12 volts constant with key out of cyclinder. the directions for some alarms and remote starts make it so hard for a backyard installer to learn how to do it right.
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.
it is true you can tap off the red wire in the ignition harness for constant 12 volts but test all wire before making connections. the other wires are as follows. ignition one-blue. ignition 2 -black orange. starter - yellow . accessory -black white.
any more help email me personally
-------------
Jon
Installer/Help Technician
---coral springs florida---
mecp certification is not always needed. I have it and it has not helped me out at all. my experience out shines it.