glue spray gun
Printed From: the12volt.com
Forum Name: Fiberglass, Fabrication, and Interiors
Forum Discription: Fiberglass Kick Panels, Subwoofer Enclosures, Plexiglas, Fabrics, Materials, Finishes, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10344
Printed Date: June 08, 2024 at 1:49 PM
Topic: glue spray gun
Posted By: messiah9966
Subject: glue spray gun
Date Posted: March 03, 2003 at 9:49 AM
What type of spray gun are you using to spray glue?Is there a specific type of gun for glue out there? I bought a cheap primer gun to spray contact cement and it is just too thick, even though i thinned the contact cement down quiet a bit. Maybe I am using the wrong type of glue? Any suggestions?
Replies:
Posted By: amador
Date Posted: March 04, 2003 at 8:52 PM
go down to your local auto upholstery and buy some glue the gun your using is fine if you ceck out the equipment they use you'll get a better picture of what type of equipment to use good luck
Posted By: audiomechanic
Date Posted: March 05, 2003 at 6:59 AM
what you can do is get a bigger tip for spraying your glue.....you can get a tip that is 1.7mm or 2.0mm this will spray the glue better......or make sure you are mixing the thinner in the glue well i mix my glue and thinner to about a 75% glue to 25% thinner and mix it well. i am just using spray grade contact cement through a cheap gravity feed spray gun.
|