interior light

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=136833
Printed Date: May 03, 2024 at 8:21 AM

Topic: interior light

Posted By: namyenruoj
Subject: interior light
Date Posted: June 18, 2014 at 5:56 PM

i bought a viper 5904v on line and installed it in my 1991 toyota celica. i/ve got the remote start working but some how i want to make the interior light to come upon disarming. still having problem.
it says to use BLACK / YELLOW but that wire has constant power 12volts. also my led from the control center where the antenna is used to work before and some how it's not working anymore. i even sent the control center back for replacement but still not working. please i need some help on how to trouble shoot these problems. thanks

-------------

Replies:

Posted By: ropuma
Date Posted: June 20, 2014 at 9:13 PM

Use wire that say dome light supervision with a relay

Posted By: namyenruoj
Date Posted: June 21, 2014 at 2:46 PM

my celica don"t have the delay interior light. and the dome light supervision from the viperr BLACK / YELLOW has constant power all the time how can i make this work more details would be appreciated

-------------

Posted By: ropuma
Date Posted: June 22, 2014 at 9:25 PM

check BLACK/ white for dome s.light (viper)
BLACK/ white to 85
12volts to 86
87 depend if you car is (-) or (+) light( toyota are -)
30 to dome light from car.
delay light is controled by viper alarm.

Posted By: namyenruoj
Date Posted: June 24, 2014 at 10:43 AM

thanks ropuma
I'm already using that BLACK/ white for my parking brake input. my celica is a manual transmission. the model for this viper alarm is 5904v
I installed a viper model 5901 for my 98 rav4 manual transmission. everything is working fine including the interior dome light. from my rav 4 i used BLACK/ white from H1 harness and it works and there is also a BLACK/ white neutral safety from RS in harness and I used that too. this model 5904v only has one set of BLACK/ white that is why I'm a little bit confused. it say in the manual to use BLACK / YELLOW but when I measure this wire the voltage to 12v supply is 12 volts constant when you arm/disarm the system the voltage never change.

-------------

Posted By: namyenruoj
Date Posted: June 24, 2014 at 11:14 AM

is the wire for the dome light output gives out negative pulse for 30 to 60 seconds delay time or gives out negative constant if you measure to constant 12 volts power

-------------

Posted By: syahrul37
Date Posted: September 27, 2014 at 8:30 AM

namyenruoj wrote:

is the wire for the dome light output gives out negative pulse for 30 to 60 seconds delay time or gives out negative constant if you measure to constant 12 volts power

30 sec delay for the domelight output.