2006 jeep commander aftermarket audio
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=137282
Printed Date: May 06, 2024 at 4:32 AM
Topic: 2006 jeep commander aftermarket audio
Posted By: harve123
Subject: 2006 jeep commander aftermarket audio
Date Posted: September 18, 2014 at 12:27 PM
Hey guys & girls I have 06 jeep commander without nav. I had a pioneer nav installed, never really worked the way I wanted and looked like crap. I have some time now to fix the install. The original install included pioneer nav upgraded speakers, sub and 2 amps. During the install the OEM radio harness was hacked, allowing him to connect wires from the harness to the pioneer harness. Now I'm trying to fix it and re-wire it. I ordered and have the original vehicle radio harness. I was recently informed, not to get the interface adapter harness, it's useless bc I'm not using the stock amp, I'm using after market amp. Was told to cut the wires from the car harness run them to my aftermarket nav harness. What wires am I connecting from the vehicle to the pioneer nav harness??? Was told it's like 4 wires I need to connect. Need desperate help any advice would be greatly appreciated.
Replies:
Posted By: i am an idiot
Date Posted: September 18, 2014 at 5:03 PM
If you are not using the factory amp, I can think of only 2 wires that you can use. Constant 12v for the yellow wire of the Pioneer. Ground for the Black wire of the Pioneer.
Other than that there is nothing else in that plug you will need.
EDIT: I was going to check and see if there was an illumination or power antenna wire, but Audiovox no longer gives audio wiring information.
Posted By: harve123
Date Posted: September 18, 2014 at 7:18 PM
Thank you very much.
|