Small MDF cuts

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=141617
Printed Date: May 02, 2024 at 2:29 AM

Topic: Small MDF cuts

Posted By: fluidics
Subject: Small MDF cuts
Date Posted: August 16, 2016 at 12:06 AM

I'm trying to figure out how to cut some 3/4 mdf for my new box. I have 6 different 45 degree cuts. The longest side of the trapezoids need to be pairs of 2", 3" and 3.5" (see image below)

https://imgur.com/a/u4GtX

How would you go about cutting the angles into such a small length? Any help or suggestions is appreciated.

Replies:

Posted By: i am an idiot
Date Posted: August 16, 2016 at 3:41 PM

Make a 3d drawing. I can not figure out what you are trying to do.

Is that the end of a board that is 10 inches long. If so, a table saw with the blade angled at 45 degrees.

Posted By: i am an idiot
Date Posted: August 16, 2016 at 3:42 PM

https://imgur.com/a/u4GtX

Posted By: tonanzith
Date Posted: August 18, 2016 at 10:30 PM

Table saw..... .. . .

-------------
Gary Sather

Print Page | Close Window