wiring my speakers, kicker comp r 12
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=142971
Printed Date: May 01, 2024 at 10:28 PM
Topic: wiring my speakers, kicker comp r 12
Posted By: eakes_effect
Subject: wiring my speakers, kicker comp r 12
Date Posted: May 17, 2017 at 7:21 PM
I recently purchased 2 kicker comp r 12 and I have a Sony xm-1652z amplifier. The specs on the amp are RMS Power: at 4 Ohms 1000 W x 2 RMS Power: at 2 Ohms 500 W x 2 Frequency Response: 5 Hz - 50000 Hz Signal to Noise Ratio: 100 dB THD at Rated RMS Power: 0.04 % Low - Pass Frequency: 80 Hz - 80 Hz MOSFET Circuitry: Yes Width: 16.69 in. Depth: 11.42 in. Height: 2.17 in. I was needing help with wiring them to get maximum power and efficiency. Currently I have them wired 4 ohm From looking on the kicker site. Any advice would be greatly appreciated. I do not have the amp bridged at this time.
|