Print Page | Close Window

Hole in Fire Wall, 96 Eagle Vision

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=22869
Printed Date: October 31, 2024 at 6:49 PM


Topic: Hole in Fire Wall, 96 Eagle Vision

Posted By: slipitysmooth
Subject: Hole in Fire Wall, 96 Eagle Vision
Date Posted: December 15, 2003 at 11:36 AM

anyone know where to look for one in a 96 ish Eagle Vision?  Couldnt find one for the life of me, looked for like an hour.



Replies:

Posted By: HamiltonAudio
Date Posted: December 16, 2003 at 8:34 PM
careful inspection, sharp drill bit and a charged drill   posted_image




Posted By: NINsane18
Date Posted: December 17, 2003 at 4:32 PM
I ran into the same problem with my 1998 Jeep Grand Cherokee. Once I removed the washer tank, there was 6 + inches of firewall to drill through safely and bring the wire in right by the kick panel. I used the bushing in the link I pasted below. It made it really easy. Just like HamiltonAudio said, grab a flash light, and look for an open area both in and out of the car, and triple check for wires or anything important before you drill. It made it easier to use a small bit for a pilot hole, then a step bit to make the right size hole for the bushing. Good Luck!

https://www.crutchfield.com/S-E3U2p8c7Ygk/cgi-bin/prodgroup.asp?s=0&cc=01&g=65400&est=&search=bushing

-------------
Tim-May!





Print Page | Close Window