Viper 1200.1 Outputs?
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=31743
Printed Date: June 09, 2024 at 4:21 PM
Topic: Viper 1200.1 Outputs?
Posted By: pilyo143
Subject: Viper 1200.1 Outputs?
Date Posted: May 06, 2004 at 11:38 PM
I was looking at viper 1200.1 manual and I'm confuse because it's a mono amp with two speaker output. The manual said they are internally parallel. How do you connect a two 12 inch dual 4 ohms diamond m6 to get a 1 ohm load. Do you wire the subs parallel 2 ohm load and then just connect one sub to one terminal. Repeat the same process on the other one. You basically wire one sub 2 ohms to the 1st speaker terminal and the other sub 2ohms also to the 2nd speaker terminal. The amp terminal are parallel inside making it to 1 ohm load the sub are not wired together but the amp terminals are. Did i get it right. Thanks in advance
Replies:
Posted By: Ketel22
Date Posted: May 07, 2004 at 3:35 AM
yes that is completely correct.
-------------
Quad L Handyman services
|