’96 Yukon 2-dr. door speaker upgrade q’s
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=39740
Printed Date: September 20, 2024 at 7:18 PM
Topic: ’96 Yukon 2-dr. door speaker upgrade q’s
Posted By: dirtydreams4x4
Subject: ’96 Yukon 2-dr. door speaker upgrade q’s
Date Posted: September 25, 2004 at 7:09 PM
I just bought a set of Polf mmc6500 components, and I have a few questions before I jump in. The speakers came with crossovers, and I dont know where to mount them, any suggestions? I'm planning to amp the speakers and I am thinking about replacing the factory speaker wire. Will it make much of a difference or should I just leave it? Also I'm not sure where I'm going to mount my amp. Any suggestions would be appreciated. Oh ya I am going to put a sub in pretty soon also so give me any suggestions you have for stealth install. My goal is to get nice clean, accurate sound over a large range. I'm not interested in rattling the doors off with bass, but I do like to hear those lows hit. Thanks--
Replies:
Posted By: forbidden
Date Posted: September 26, 2004 at 4:06 PM
Run new speaker wires. Mount the crossovers inside the vehicle, not inside the door where moisture will detroy them.
-------------
Top Secret, I can tell you but then my wife will kill me.
|