98 sebring strange wiring

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=50739
Printed Date: May 18, 2024 at 2:02 AM

Topic: 98 sebring strange wiring

Posted By: crook
Subject: 98 sebring strange wiring
Date Posted: February 24, 2005 at 3:54 AM

my dad has a 98 sebring, which is chrysler/mitsubishi, i had a fit kit, and wiring harness already wired up i pulled from my neon i sold, same fact. plugs so i connect it and the deck is on and fine but no sound. pluged the stock cd player back in and there is sound.

the wiring on the harness can't be faulty cause it worked fine in my neon.. this is probly somthing simple but i can figure it out, and its like 10 degrees outside so i get sick of trouble shooting after like 3min.

the stock mitsu cd player's screen went out but it still works. i also found it wierd i couldnt "pop" the front speaker with a 9 volt..

i remember installing a cd player in my sisters 98 eclipse and the car is basicly the same inside/wires. it worked fine.

Replies:

Posted By: crook
Date Posted: February 24, 2005 at 4:21 AM

i just thought of, maybe this car has an amp... some one correct me if im wrong.. it has the cd/tape deck with the joystick to fade.. no infinity logo though

Posted By: crook
Date Posted: February 24, 2005 at 4:22 AM

i just thought of, maybe this car has an amp... some one correct me if im wrong.. it has the cd/tape deck with the joystick to fade.. no infinity logo though.

if it does have an amp, should i run the pioneer deck though it ? or by pass it? whats the best and or easiest way to by-pass?

Posted By: crook
Date Posted: February 24, 2005 at 2:33 PM

nevermind. im lazy and slow sometimes.

Posted By: jmckinney10
Date Posted: February 24, 2005 at 8:41 PM

if it has an amp it will be mounted underneath the rear deck and is not hard to rewire.

Posted By: Asmodeus
Date Posted: February 24, 2005 at 8:57 PM

You just need to power the amp...Find the remote turn on in the factory harness and put remote power to it...

-------------
posted_image

Making the World A Louder Place

Posted By: tcss
Date Posted: February 26, 2005 at 2:59 PM

Amp turn on lead is the green wire at the end of the speaker plug. needs 12 volts