Removing Factory amp

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=67050
Printed Date: May 03, 2024 at 6:42 PM

Topic: Removing Factory amp

Posted By: Dsteinmann
Subject: Removing Factory amp
Date Posted: November 26, 2005 at 11:09 AM

I want to remove the factory amp in a 99 300m whats the easy way to get the wires reconnected?

Replies:

Posted By: rottenbelly
Date Posted: November 26, 2005 at 7:17 PM

Most companys that make install kits make factory amp bypass connectors. Let the hunt begin!

-------------
rottenbellys 05 crew cab colorado.Pioneer dehp 880prs, kenwood excelon in all 4 doors. Bazooka 500 mono Jl 10w3 in coustom center console box.

Posted By: opy1095
Date Posted: November 26, 2005 at 9:04 PM

are u gonna add an aftermarket amp and/or headunit?

Posted By: Dsteinmann
Date Posted: November 27, 2005 at 2:50 PM

headunti and amp,

Posted By: godblessdremil
Date Posted: November 27, 2005 at 4:25 PM

two ways to bypass the amp, bolth basacally do the same thing. One run speaker cable to the amp, and just disconnect the speakers from the amp and connect them to said wires, then use the other end for your purpose(eather hooking it up to an amp or a head unit). The other is to buy a plug from anyone who makes harnesses and use that. The advantage to that you keep the factory harness intact, no possibillity of mistake since its just match up colors, disadvantage to previous is its slightly more expensive.

Posted By: ssnds
Date Posted: November 27, 2005 at 5:40 PM

i would just install the HU, run new speaker wires from all the speakers to the trunk (where the amp would be). or i am guessing you could fight out which wires on the amp are for which speakers.. and go that route.

was that any help? k thanks

-------------
SSounds