Alpine head unit 7895 no sound problem
Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=76503
Printed Date: May 18, 2024 at 1:47 PM
Topic: Alpine head unit 7895 no sound problem
Posted By: Focusedonsound
Subject: Alpine head unit 7895 no sound problem
Date Posted: April 20, 2006 at 8:55 AM
Problem: CDA-7895 Plays find for about 30-60 seconds and then sound drops out.
Background: About 2 weeks ago I added the KCA-420i to the system with no problems I dropped off my car for some suspension work last thursday and picked the car up yesterday. While the shop had it. My battery went dead.
How the system is hooked up: The Radio is connected to the factory harneses via a Metra adapter. I do not use the radio's internal amp's. I come out of the Radio w/ 1 RCA(rear) and go into a Kenwood EQ/crosover. From there the signal is split in to (3) (1) Front amp Alpine (2) Rear amp Alpine (3) RF Sub amp.
Here is what I have checked so far.
Fuses. all my fuses seem to be intact I haven't dug to far just yet though.
RCA Cables It doesn't seem like a problem between the Headunit and EQ I tried eliminating the EQ same results
Any suggestions on which way to go in regards to trouble shooting this problem?
Replies:
Posted By: tcss
Date Posted: April 20, 2006 at 12:35 PM
Try resetting the deck first. After that I would look at the amp grounds ( I'm assuming the amps are coming on)
-------------
There is no such thing as free installation!
Posted By: Focusedonsound
Date Posted: April 20, 2006 at 1:45 PM
I haven't tried "re-setting" yet. I will do that this afternoon. Should I disconect the KCA-420i when doing so?
Posted By: tcss
Date Posted: April 20, 2006 at 4:34 PM
No leave the 420i hooked up.
-------------
There is no such thing as free installation!
|