Print Page | Close Window

multi-channel amp

Printed From: the12volt.com
Forum Name: Car Audio
Forum Discription: Car Stereos, Amplifiers, Crossovers, Processors, Speakers, Subwoofers, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=79429
Printed Date: October 31, 2024 at 6:47 PM


Topic: multi-channel amp

Posted By: loudazzjeep07
Subject: multi-channel amp
Date Posted: June 21, 2006 at 10:51 PM

i just bought a 4-channel amp for my 4 door speakers.  i have a couple of questions on wiring.

for starters, i am going to mount it under the passenger seat, (the battery is already on that side) and i have the power, ground, and remote turn on lead's already hooked up, but not to the amp yet.

i was wondering how do i run the speaker wire to the speakers from the amp?  also, how do you connect the speakers into the entire set up? do you have to connect them to both the head unit and the amplifier, or only the amplifier?

also, how (and how many) and where do i run the rca cables? to what do they connect to (from the amp)?

any help on this would be greatly appreciated!!! thank you very much to those who contribute!!!



-------------
Jeep + woofers = LOUD AS HELL



Replies:

Posted By: stevdart
Date Posted: June 21, 2006 at 11:09 PM
Are you using the original factory deck or do you have an aftermarket deck installed?

-------------
Build the box so that it performs well in the worst case scenario and, in return, it will reward you at all times.




Posted By: aznboi3644
Date Posted: June 22, 2006 at 1:13 AM
Look at the sticky on wiring through a door molex.




Posted By: loudazzjeep07
Date Posted: June 22, 2006 at 12:09 PM
it is an aftermarket alpine deck

-------------
Jeep + woofers = LOUD AS HELL





Print Page | Close Window