scytek, releys
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100523
Printed Date: May 28, 2024 at 1:34 PM
Topic: scytek, releys
Posted By: jay3000
Subject: scytek, releys
Date Posted: December 28, 2007 at 9:21 PM
I'm putting the finishing touches on my alarm rs and, I have ran into something that's kind of wierd. The alarms trunk output wire is gray(aux1) and WHITE/ red is the aux2. Okay I have wired my relay like this
87 to car trunk wire(+)
86 to grey wire alarm(-)
85&30 to 12v(+)
My question is the aux2 pops the trunk fine but the aux1 will not pop trunk,What am I doing wrong.?
Replies:
Posted By: tedmond
Date Posted: December 29, 2007 at 12:16 AM
test to see if aux 1 works. the relay setup is correct.
Posted By: jay3000
Date Posted: December 29, 2007 at 12:24 AM
Could u share how to do that?
Posted By: tedmond
Date Posted: December 29, 2007 at 12:08 PM
grab your volt meter. connect red to constnat 12volts and take the black and connect taht to your aux. hit the aux and it should read 12 - 14.4 volts. if there is nothing, it might be that aux 1 is optional for programming. or you fried the output.
Posted By: audioman2007
Date Posted: January 06, 2008 at 9:04 PM
no no no. your aux 2 output is for your trunk release. You have to hold that button for 3 seconds for the trunk lid to open correct? The aux 1 output is for stuff like a window module and is factory programed differently. If you want to use aux 1 though, look in your manual and it will tell you how to reprogram aux 1. Which alarm you have?
Posted By: chriswallace187
Date Posted: January 07, 2008 at 6:32 PM
Aux 1 on any Scytek should operate the trunk release, unless you've programmed a custom button configuration. Are you holding the button for several seconds?
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: audioman2007
Date Posted: January 07, 2008 at 7:59 PM
yea i got that backwards. thanks for clearing that up Chris.
|