04 tahoe door locks

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=100952
Printed Date: May 28, 2024 at 4:01 PM

Topic: 04 tahoe door locks

Posted By: helmsb
Subject: 04 tahoe door locks
Date Posted: January 08, 2008 at 9:32 PM

used a xk01 interface with a valet 562t . The doors unlock fine if you use the rs, but if you just walk up and press the remote unlock you have to press it 3 times . I have programed it to work the lock and unlock on 1 pluse. Is there something I am missing

Replies:

Posted By: Twelvoltz
Date Posted: January 09, 2008 at 7:24 AM

What unlock wire(s) from the 562T did you use to interface with the XK01? Test the outputs from the 562T to make sure they are providing a ground output when unlocking. Although I have never had an issue I have read some posts where the low current output from the brain of the RS was not enough for the bypass to activate and relays were required to give a stronger ground pulse to the bypass.

-------------
Installer, IT support, and FFL. I need less hobbies.

Posted By: helmsb
Date Posted: January 09, 2008 at 6:02 PM

I used the green and blue out of the door lock harness. What it is doing is the first time you push the button it clicks but nothing the 2nd time it locks the doors back then the 3rd it unlocks just fine.

Print Page | Close Window