03 Chevy Truck 1 ton
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=10385
Printed Date: May 28, 2024 at 7:07 PM
Topic: 03 Chevy Truck 1 ton
Posted By: jmyinc
Subject: 03 Chevy Truck 1 ton
Date Posted: March 03, 2003 at 9:34 PM
I need a wire diagram for this vehicle, also anything I should be aware of before i install a remote start alarm, I am adding power door locks and I bought a passlock bypass kit.
Thanks,
Morgan
Replies:
Posted By: jrilla
Date Posted: March 03, 2003 at 10:26 PM
ITEM | WIRE COLOR |POL| WIRE LOCATION |
| 12V|red (x2) |+ |ignition harness |
| STARTER|yellow |+ |ignition harness |
| IGNITION|pink (12 awg) |+ |ignition harness |
| SECOND IGNITION|white |+ |ignition harness |
| ACCESSORY|orange |+ |ignition harness |
| SECOND ACCESSORY|brown |+ |ignition harness |
| POWER LOCK|use Directed module | | |
| POWER UNLOCK|part #456G *2 | | |
| LOCK MOTOR|gray | |driver door module in door |
| UNLOCK MOTOR|tan | |driver door module in door |
| DISARM DEFEAT|tan | |pass. door module in door |
| PARKING LIGHTS +| | | |
| PARKING LIGHTS -|gray/black | |brown plug @ BCM *1 |
| HEADLIGHTS| | | |
| DOOR TRIGGER|gry/blk(L),blk/wht(R|- |each door module in door *3 |
| DOME SUPERVISION|use door trigger | | |
| TRUNK/HATCH PIN| | | |
| HOOD PIN| | | |
|TRNK/HTCH RELEASE| | | |
| FCTRY ALARM ARM|arms with lock | | |
|FCTRY ALRM DISARM|lt. green |- |driver door module in door |
| TACHOMETER|NOT pnk, blk, or brn| |any ignition coil |
| SPEED SENSE| | | |
| BRAKE WIRE|white |+ |brake pedal switch |
| HORN TRIGGER|black |- |steering column |
| WIPERS|pink |- |steering column |
| LF WINDOW UP/DN|blue - brown |A |driver window motor |
| RF WINDOW UP/DN|blue - brown |A |passenger window motor |
NOTE: This vehicle has the passlock II immobilizer system that, when adding a remote start, must be interfaced with. The passlock II wire colors are yellow, black, and RED / white (not used). *1 The BCM (Body Control Module) is under the driver side dash. *2 If Directed module part #456G is not available, refer to directfax document #1601. On base model trucks the lock wire is lt. blue (-) and unlock wire is white (-). They are in the lt. blue plug at the BCM. *3 On base model trucks the door trigger wires are in the lt. blue plug at the BCM. On 4dr trucks the LR door trigger is lt. blue/black, and the RR is lt. GREEN/ black. They are in the purple plug at the BCM. Use all wires and diode isolate.
------------- J Rilla
Owner/Installer
Posted By: jmyinc
Date Posted: March 09, 2003 at 10:30 AM
I cant find the passlock wires, help!!
Posted By: jrilla
Date Posted: March 09, 2003 at 10:45 AM
Passlock wires are very thin gauge wires coming from the key cylinder. The ones you need are ORANGE / Black and Yellow.
I would suggest using a PLDATA to bypass the passlock though since it makes the install a piece of cake and it only takes a few minutres to install. You should also get a GMDL4 databus interface module. Take a look at them here:
GMDL4
PLDATA
You should definatley get the GMDL4 if not both though. ------------- J Rilla
Owner/Installer
Posted By: jmyinc
Date Posted: March 09, 2003 at 12:13 PM
Ok i have a yellow, RED / white, and a black. I have a bypass module and cut the yelllow wire and put them to the specified locations on the bypass thing and it wont start.
Posted By: jmyinc
Date Posted: March 09, 2003 at 1:04 PM
I have an 03 chevy pickup that will not start, it turns over but then dies. I hooked up the passlock 2 system and cut the yellow wire and noow it wont even start with the key. I pulled off the neg batt canble and and it sdtill dont work. help
thanks
Posted By: jmyinc
Date Posted: March 09, 2003 at 1:06 PM
I just insstalled rs on 03 cjhevy pu, it wont start at all now, just turns over. I installes the passlock 2 thing and it said cut the yellow wire coming off the key cylender, i did now it woint start.
help fast please
Posted By: jrilla
Date Posted: March 09, 2003 at 1:46 PM
OK you need to tap that black wire. I thought all pickups and SUVs were ORANGE / Black, but maybe on the 2003 they went to Black.
Didnt your bypass module tell you to hook up a wire to the black passlock ground wire? What bypass module is it?
------------- J Rilla
Owner/Installer
Posted By: Velocity Motors
Date Posted: March 09, 2003 at 4:08 PM
Did you hook up your ground out when running wire to the bypass module ?
------------- Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: jmyinc
Date Posted: March 09, 2003 at 8:57 PM
I figured it out.
Thanks for all of the help, you guys are great!
Morgan
|