2000 Dodge Durango Disarm Wire

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=1053
Printed Date: May 11, 2024 at 6:28 AM

Topic: 2000 Dodge Durango Disarm Wire

Posted By: wikkedkustoms
Subject: 2000 Dodge Durango Disarm Wire
Date Posted: May 31, 2002 at 12:32 AM

Installed a remote start/keyless entry system into a 2000 dodge durango, everything works fine, however if you shut the doors and try to start the car remotely within say 2 minutes it triggers the factory alarm, which kills the ignition curcuit, sounds the horn and flashes the lights. I know that I need to hook up the disarm (-) output off the alarm to the wire in the car but am not sure the correct color please verify for me if possible. Wire color = lt. GREEN/ orange in drivers kick panel. Thanks

Replies:

Posted By: install_tech
Date Posted: May 31, 2002 at 4:12 AM

That is the correct wire. A ground pulse through a 1500 ohm resistor will disarm the factory alarm.

Hope this helps.

-------------
install_tech

Posted By: scss
Date Posted: June 01, 2002 at 11:59 PM

Since the door locks are + you have to use relay to convert it to negative and hook up to light GREEN/ orange in connectors next to parking brake assembly. You have to pulse unlock (+) and disarm (-) at the same time.

-------------
Jando
Security Specialist
If its a Ford Dont do it