viper 5900 and xk01 remote start problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=106736
Printed Date: May 13, 2024 at 10:09 AM
Topic: viper 5900 and xk01 remote start problem
Posted By: noreason
Subject: viper 5900 and xk01 remote start problem
Date Posted: August 12, 2008 at 11:00 PM
I finished my install in an 06 Chevy Silverado 1500 (non classic) and when I activate the remote start it cranks, fires, and dies immediately. With the key in the ignition and in the ON position, everything works fine. I'm using the XK01 Bypass Module which seems to be working fine since it unlocks/locks/senses all doors. Any ideas?
Replies:
Posted By: chriswallace187
Date Posted: August 12, 2008 at 11:23 PM
Just verifying, this is the old body style, and not the one that's being sold right now?
If the XK01 is doing all that it doesn't sound like a firmware issue; I would check your ground-when-running(status) wire connection.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: noreason
Date Posted: August 13, 2008 at 1:25 AM
Yes, the body is different than the one being sold now. I couldnt find concrete evidence to what wire to connect the ground when running, so I followed information on this form, which was "blue status output on the little 4 pin harness on the relay pack". It seems to ground when I remote start the car...
Posted By: kgerry
Date Posted: August 13, 2008 at 4:20 PM
did you verify you have the XK01 programmed for the correct platform? and did you program the XK01 after wiring it up? ------------- Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: noreason
Date Posted: August 13, 2008 at 7:52 PM
Theres a good chance I programmed it too soon... Its programmed to type 4 but I cant seem to figure out how to reprogram it again. How do you reset this thing? I do what the instructions say but nothing happens except the led turns red each time i press the program button. I disconnected the cable and reconnected and tested it that way too and the LED stays red apon power up like its suppose to but then when turn the key to ON like the instructions say the LED blinks 4 times and goes off.
Posted By: Chris Luongo
Date Posted: August 13, 2008 at 8:05 PM
Also, since it works with the key on, but not with the key off, test that all of your ignitions and accessories are being powered up by the remote starter.
Test that the pink and the white are receiving power in Run AND Start.
Test that the orange is receiving power in Run ONLY.
Test that the yellow is receiving power in Start ONLY.
|