idatalink ads al ca door status output

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=108569
Printed Date: June 04, 2024 at 8:59 PM

Topic: idatalink ads al ca door status output

Posted By: Komobu
Subject: idatalink ads al ca door status output
Date Posted: October 31, 2008 at 3:50 PM

Hi;

I am installing a remote start on a 2004 Jeep. I am using the idatalink bypass. Hooking the wires from the remote start to the idatalink module is relatively easy. I have a question about hooking the idatalink module to the car though.

It tells me to hook a pink wire to 12v ignition
One wire to ODBII Data Port Pin 2
It then says that a yellow/black wire is for door status neg output. What does this mean? does this hook back up to the alarm portion of the remote start?

Thanks for any help

Replies:

Posted By: revolutionz_s13
Date Posted: October 31, 2008 at 6:07 PM

If you're not doing an alarm you wont need to worry about this wire. This will just give you the door status output to connect to the alarm system. Not sure why you would hook up a door trigger on this vehicle for a remote start.

Posted By: dcorwin822
Date Posted: January 08, 2009 at 6:08 PM

manual transmission?

Posted By: loneranger
Date Posted: January 08, 2009 at 6:40 PM

domelight supervision?

Posted By: loneranger
Date Posted: January 08, 2009 at 6:41 PM

passive locking?

Print Page | Close Window