04 monte carlo locks problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112259
Printed Date: October 31, 2024 at 6:49 PM
Topic: 04 monte carlo locks problem
Posted By: mike1109
Subject: 04 monte carlo locks problem
Date Posted: March 10, 2009 at 11:19 PM
Ok i hooked up a Prestige (audiovox) ap997 alarm but i cant get the lock to work i read the direct alarm install wiring diagram. their are three wires for the locks a green, red, RED / black. i hooked up the green wire for the unlock and it unlocks i tried hooking up a 470 resistor for the RED / black lock but it want work i have tried. to use two relays but had no luck. i need some help guys
Replies:
Posted By: james bond 007
Date Posted: March 11, 2009 at 9:20 AM
orange with black stripe wire for your locks this is a multiplex, a neg (-) through a 480 ohm resistor will lock all the doors and a staight neg (-) on the same wire will unlock the doors
Posted By: Mike M2
Date Posted: March 11, 2009 at 4:50 PM
Use must use relays!!
------------- Mike M2
Tech Manager
CS Dealer Services
Posted By: mike1109
Date Posted: March 12, 2009 at 1:41 AM
so 470 ohm resistors dont work and what way should i wire the relays up
Posted By: Mike M2
Date Posted: March 12, 2009 at 6:40 AM
Look at the top of this page, click door locks, click single wire locks, look at Ford Probe. These are similar but different as in your case pin 87 gets grounded instead of 12volts(because they are negative locks) and the resistor goes on lock not unlock.
------------- Mike M2
Tech Manager
CS Dealer Services
Posted By: mike1109
Date Posted: March 13, 2009 at 10:31 AM
Ok so the relay is still going to have power running to it through 85 and ground 87 run locks to 86 and resistor to from 30? Should i use two relays or one.
Posted By: Mike M2
Date Posted: March 13, 2009 at 5:42 PM
You need two relays, one for both lock and unlock. Wire it as you stated and you will be fine...
------------- Mike M2
Tech Manager
CS Dealer Services
|