Print Page | Close Window

97 sunfire passlock1

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112381
Printed Date: October 31, 2024 at 6:50 PM


Topic: 97 sunfire passlock1

Posted By: 97sunflower
Subject: 97 sunfire passlock1
Date Posted: March 15, 2009 at 12:06 PM

I installed a prostart along with a DEI 556lw in my 97 Sunfire. The problem I am having is getting the 556 to learn the resistance. I followed the book on how to program it cycle the key on off 2 times then start them car. The status led on the 556 doesn't blink like it's suppose to it just stays on. This is how I wired the 556 in brackets is where I wired the harness to on the car.

GREEN/ BLACK—(not used)
BLACK/ WHITE—(-) bulb check (black wire in black connector on left side of key cylinder)
BLACK—Passlock ground (Ground)
PINK—(+) ignition (Pink ignition wire)
BLUE—(-) status input (Ground when running on Remote Start)
VIOLET—(-) crank input (to ground through relay on start wire)
RED—(+) 12V (constant 12v)
WHITE—(not used)
YELLOW—key side resistance in (yellow passlock wire key side)
WHITE/ YELLOW—(not used)
BLACK / YELLOW—vehicle side resistance out (yellow passlock wire vehicle side)

If someone could help me out it would be greatly appreciated this is my first time doing a remote start but I'm not new to electrical.



Replies:

Posted By: tedmond
Date Posted: March 16, 2009 at 11:33 PM

VIOLET—(-) crank input (to ground through relay on start wire)

start wire coming off of the harness is a postive output. you got a positive crank output going into the bypasses negative crank input.





Posted By: 97sunflower
Date Posted: March 17, 2009 at 7:29 PM
I have a relay on the start wire which sends the violet wire to ground while the engine is being started





Print Page | Close Window