door trigger wires, 02 lincoln ls
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=112791
Printed Date: June 07, 2024 at 10:53 AM
Topic: door trigger wires, 02 lincoln ls
Posted By: leoeayers
Subject: door trigger wires, 02 lincoln ls
Date Posted: March 30, 2009 at 2:12 PM
I have a 02 lincoln ls and was wondering if someone could give me the individual door trigger wire colors and locations? Thanks
Replies:
Posted By: dansi187
Date Posted: March 30, 2009 at 7:12 PM
What model is it?
Posted By: dansi187
Date Posted: March 30, 2009 at 7:13 PM
| PART | COLOR | LOCATION | | 12 VOLT CONSTANT | RED (+) | IGNITION SWITCH HARNESS | | STARTER | GRAY/BLACK (+) | IGNITION SWITCH HARNESS | | STARTER 2 | N/A | | | IGNITION 1 | GREEN/ BLACK (+) | IGNITION SWITCH HARNESS | | IGNITION 2 | PINK/WHITE (+) | IGNITION SWITCH HARNESS | | IGNITION 3 | N/A | | | ACCESSORY /HEATER BLOWER 1 | YELLOW (+) | IGNITION SWITCH HARNESS | | ACCESSORY /HEATER BLOWER 2 | PINK / YELLOW (+) | IGNITION SWITCH HARNESS | | KEYSENSE | N/A | | | PARKING LIGHTS ( - ) | WHITE/ GREEN (-) See NOTE *1 | @ HEADLIGHT SWITCH | | PARKING LIGHTS ( + ) | DO NOT USE! | | | POWER LOCK | BLACK/ BLUE (Negative (-)) | @ DDM Module, See NOTE *2 | | POWER UNLOCK | BLACK/ WHITE (Negative (-)) | @ DDM Module, See NOTE *2 | | DOOR TRIGGER | BLACK/ WHITE (-) | @ UNDER DASH LIGHT | | DOMELIGHT SUPERVISION | TURNS ON with UNLOCK | | | TRUNK RELEASE | WHITE (-), Requires Part #R30-H Relay | @ TRUNK RELEASE SWITCH | | SLIDING POWER DOOR | N/A | | | HORN | BROWN / RED (-) See NOTE *4 | @ FEM Module, See NOTE *3 | | TACH | BROWN or wire with BROWN STRIPE | @ MAIN HARNESS, PASSENGER FIREWALL | | WAIT TO START LIGHT | N/A | | | BRAKE | ORANGE / YELLOW (+) | @ SWITCH ABOVE BRAKE PEDAL | | FACTORY ALARM DISARM | DISARMS WITH UNLOCK | | | ANTI-THEFT | FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM | TRANSPONDER @ IGNITION SWITCH TUMBLER |
Posted By: dansi187
Date Posted: March 30, 2009 at 7:14 PM
NOTE *1 the Parking Light Circuit will requires extra parts, a Relay part #R30-H and a (-)Negative thru a 1800 Ohm resistor, to connect, See DIAGRAM. NOTE *2 the DDM (Drivers Door Module) is located in the Center of the DRIVERS DOOR. NOTE *3 the FEM (Front Electronic Module) is located in the DRIVERS KICK PANEL, NOTE *4 the HORN wire can also be found at the Steering Column it is a ORANGE / YELLOW (-)
Posted By: leoeayers
Date Posted: March 30, 2009 at 7:26 PM
I have all that info already the alarm is installed everything works great except the alarm falses do to the door trigger I hooked to the BLACK/ white wire(-) @ the domelight under dash I have tried isolating it with a relay still the same. I need each door trigger wire to try and diode isolate each switch. According to research that I have done everywhere it has to do with the computer going to sleep then sending out a signal about every 30 mins to see if any lights are on which is enough to trigger the alarm.
Posted By: leoeayers
Date Posted: March 30, 2009 at 7:28 PM
dansi187 wrote:
What model is it?
If you mean the alarm it is the viper 5900 car is a lincoln ls
Posted By: mikvot
Date Posted: March 30, 2009 at 9:37 PM
My notes show BLACK / YELLOW(-) at fem module in drivers kick. Chances are, on that car, even if you do find all the door triggers..they will rest at (-) and will show open when the door is open.
-------------
Posted By: leoeayers
Date Posted: March 31, 2009 at 9:13 AM
mikvot wrote:
My notes show BLACK / YELLOW(-) at fem module in drivers kick. Chances are, on that car, even if you do find all the door triggers..they will rest at (-) and will show open when the door is open.
What would that wire be and does it need a relay or diode
Posted By: chev104275
Date Posted: March 31, 2009 at 10:19 AM
the only BLACK / YELLOW wire i can find at the FEM is in a 20 pin connector pin 8 but it still rests on ground and open when the door is open
-------------
If i Can't Install it I Don't need it Joe
Posted By: leoeayers
Date Posted: March 31, 2009 at 10:37 AM
chev104275 wrote:
the only BLACK / YELLOW wire i can find at the FEM is in a 20 pin connector pin 8 but it still rests on ground and open when the door is open
The BLACK/ yel wire is for the Dirvers door and yes checking diagrams online I have found that I guess all the door switches rest @ ground then open when the door is open. Does anyone have any ideas on how to work around theis mess.
Posted By: chev104275
Date Posted: March 31, 2009 at 11:27 AM
HOWIE II already told you (there is a specific DEI accessory to counter this and revert to normally closed (i.e. goes to ground) when door is opened. Test to see if this is the case then speak to DEI tech for the part details)
-------------
If i Can't Install it I Don't need it Joe
Posted By: leoeayers
Date Posted: March 31, 2009 at 12:50 PM
chev104275 wrote:
HOWIE II already told you (there is a specific DEI accessory to counter this and revert to normally closed (i.e. goes to ground) when door is opened. Test to see if this is the case then speak to DEI tech for the part details)
I understand that however what I dont understand is why nobody else has had this prob with the lincoln ls also how would I speak with a dei tech. they are absolutley no help unless you are an installer and most installers Ive asked will only tell me to bring it in and they will do it!
|