mitsubishi express aka l300 alarm

Hi, I am doing an alarm install in a 2008 Mitsubishi Express also know as a mitsuishi L300 this weekend and I urgently need a wire diagram to help! (Am new at installing :s)

If you have a wiring diagram or any tips regarding these vans please let me know.

Thank you so much!

Also I have been asked to do an install in a toyota corolla 2008 and I am trying to figure out if it is CAN BUS but I can't find any solid information. Any ideas on this?

Cheers!

Tim

Look up any similar Mits here, it will be the same, but you'll need indicators;  they are usually GREEN/ YELLOW and GREEN/ blue or GREEN/ black. The Toy will not be can, indicators are on left hand floor loom as is all door inc trunk contacts, one of 2 RED / whites. Check. Lock/unlock wil be in a plug, low current neg in DKP.  Assuming right hand drive and the presence of a factory actuator in Mit's driver's  door, there's an electronics box above pedals, 2 of the bottom three cables (hard to get at)  exiting towards middle of floor space will be low current neg. lock/unlock. These comments for both vehicles apply to UK spec, the Corola (now called Auris in Europe)  is UK built, L300s are built in Japan or Thailand

Just got back from giving the corolla a go.
All of the wires were different to the wire diagram. Not too much of a big deal I found everything I needed apart from the central locking.. :s So will need to go back to get it done. I found some wires which I thought were the ones,

But then realised they were negative and pulsed positive for unlock/lock.
The alarm I am working with only has Neutral and pulse either negative or positive for unlock.

Any ideas?

Tim

You've found the Corolla motor wires, look at plugs in DKP, probably green and brown, grounding them will lock and unlock the vehicle.

Ok here's a photo of the DKP wires. I found the Red and Brown on the grey plug, but they were the wrong ones. I thought I checked everything but obviously not. Any ideas where the right ones would be?

Cheers!