07 dodge nitro wiring discrepancy

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116416
Printed Date: May 14, 2024 at 2:12 AM

Topic: 07 dodge nitro wiring discrepancy

Posted By: tbird2340
Subject: 07 dodge nitro wiring discrepancy
Date Posted: September 19, 2009 at 3:25 PM

I am doing a 2007 Dodge Nitro using a Compustar CM5200 and an Idatalink ADS-DLSL CH3 bypass..

In the bypass manual it has that pins 6 & 7 (CANH and CANL) should be WHITE/ Black and WHITE/ Light Blue..

posted_image

However, when in the actual vehicle pin 7 is WHITE/ light blue (which is correct according to the diagram) but pin 6 is WHITE/ green?

There is a WHITE/ gray (that could be WHITE/ black I guess) but that is in Pin 2..

What do I do here??

Thanks!

Replies:

Posted By: beegbie
Date Posted: September 19, 2009 at 8:12 PM

I would always go by pin location not wire color.

Posted By: tbird2340
Date Posted: September 19, 2009 at 8:19 PM

Thanks for the reply..

Is there any way to test (volt meter?)?

Posted By: beegbie
Date Posted: September 19, 2009 at 9:09 PM

I don't think so. Never tried.

Posted By: tbird2340
Date Posted: September 21, 2009 at 11:07 AM

I don't feel comfortable not knowing which is 100% correct.. If I do hook it up by location and not color, and it isn't correct, will it damage anything or just not work?

Thanks

Print Page | Close Window