Print Page | Close Window

95 bmw m3 wiring

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116467
Printed Date: October 31, 2024 at 7:03 PM


Topic: 95 bmw m3 wiring

Posted By: installerman23
Subject: 95 bmw m3 wiring
Date Posted: September 21, 2009 at 3:40 PM

I was wondering if anybody has worked on this car recently.I've heard conflicting reports that most of the wires I need for a alarm are found at the factory alarm plug behind the glovebox and lock/unlock is a 5-wire.Can anybody confirm this???     



-------------
installing, one day at a time..



Replies:

Posted By: richl68
Date Posted: September 21, 2009 at 4:43 PM
12 VoltsRED / wht or red+ignition harness
Second 12 Voltsposted_imageposted_imageposted_image
Starterblk/yel or grn/blk+ignition harness
Second Starterposted_imageposted_imageposted_image
Ignitiongreen+ignition harness
Second Ignitionpur/wht or purple+ignition harness




Posted By: richl68
Date Posted: September 21, 2009 at 4:44 PM
Power LockWHITE/ red+factory alarm plug
The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Power Unlockblue/red+factory alarm plug
The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point




Posted By: richl68
Date Posted: September 21, 2009 at 4:44 PM
Parking Lights (-)blue/green (hazards)posted_imagefactory alarm plug
The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Parking Lights (+)gry/pur, gry/yelposted_imageheadlight switch
These wires are the separate left and right parking light wires. Use both wires and isolate each.




Posted By: richl68
Date Posted: September 21, 2009 at 4:45 PM
Headlightyellowposted_imageheadlight switch
AutoLightsposted_imageposted_imageposted_image
Reverse Lightposted_imageposted_imageposted_image
Left Front Door Triggerposted_image-factory alarm plug
The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point. Door triggers are BROWN / gray for the drivers front door, BROWN / blue for the passenger front door, and BROWN / white for the rear doors (if equipped). Use all three wires and diode isolate each.




Posted By: richl68
Date Posted: September 21, 2009 at 4:45 PM
Dome Supervisioncomes on with unlockposted_imageposted_image
Trunk/Hatch PinBROWN / white-factory alarm plug
The alarm plug is a black 12 pin plug located just behind the glove box. It is mounted with the pins facing you atop a vent just to the left of the body computer. Other wires at the alarm plug are: 12V- RED / white; Accessory- PURPLE / white; Siren- BLACK/ blue; Ground- BROWN / orange. Do not use the power sources at the alarm plug to operate high-current devices. The other side of the siren wire is mounted in a 2 pin plug at the passenger rear corner of the engine compartment. The other wire in the plug is a brown ground wire. DEI recommends attaching the siren at this point.
Rear Glass Pinposted_imageposted_imageposted_image
Hood PinPURPLE / green-posted_image
Located in a single pin connector next to the factory alarm plug.




Posted By: richl68
Date Posted: September 21, 2009 at 4:45 PM
Factory Alarm Armfactory remote onlyposted_imageposted_image
Factory Alarm Disarmfactory remote onlyposted_imageposted_image
Disarm No Unlockposted_imageposted_imageposted_image
Trunk Alarm Shuntposted_imageposted_imageposted_image
TachometerblackACinstrument cluster
The wire is located in a white connector behind the instrument cluster. Do not unplug the white connector with the ignition on or turn the ignition on with the plug disconnected.




Posted By: richl68
Date Posted: September 21, 2009 at 4:47 PM
Speed SenseBLACK/ whiteposted_imageradio harness
Brake Wireblue/red+at brake pedal switch
Parking Brakeposted_imageposted_imageposted_image
Horn TriggerBROWN / red-steering column
Wipersblk/gry and blk/blu-steering column

sorry it doesnt let me post it all in one reply....hope this help :-)





Posted By: installerman23
Date Posted: September 21, 2009 at 7:52 PM
Thanks for the reply             I see directechs saying it's a positive signal but the12volt says 5wire for unlock and my co-worker said he remembers having a hard time with directechs wiring diagram on that car so I just wanted to double check before I got into this thing 

-------------
installing, one day at a time..




Posted By: howie ll
Date Posted: September 22, 2009 at 10:35 AM
E36 Was POS 2 wire lock unlock. Increase lock time (5 secs for windows only, 12 secs for windows roof). You can also pick up the leads at the quadlock on the body control unit,behind the glove box. This will be the middle plug and pin 4 (bare is lock, 17 blue/red unlock), also separate door contacts these are in the r/hand quadlock, same location, BROWN / grey and BROWN / blue or brown / YELLOW all with yellow dots, diode together. Arming and disarming at those points will control the factory alarm. No dome light supervisiion required, remote lock and unlock will control them.





Print Page | Close Window