Print Page | Close Window

2006 mercedes c230 alarm

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=116719
Printed Date: June 11, 2024 at 5:54 AM


Topic: 2006 mercedes c230 alarm

Posted By: p/t installer
Subject: 2006 mercedes c230 alarm
Date Posted: October 04, 2009 at 9:02 PM

2006 mercedes c 230, i am putting a python alarm into this car and unsure where where to find the door lock/unlock wires, as well as the door pins and trunk pin wire.  i beleive i found the ignition wires coming from the smart key port . how about the domelight instead of the individual door pins? where is the domelight wire? i've heard of lots of unsuccessful attempts with mercedes vehicles, should i just stay away from this car? or is somebody sure of the wire colors and locations? or for that matter, has anyone ever put an alarm in a 2006 c 230 and had success? heeeeeeeeeeelp! thanx in advance



Replies:

Posted By: i am an idiot
Date Posted: October 04, 2009 at 9:08 PM
posted_imageBatteryRED(+)IGNITION SWITCH HARNESS
posted_imageIgnition 1PINK/RED(+)IGNITION SWITCH HARNESS
posted_imageStarter 1VIOLET(+)IGNITION SWITCH HARNESS
posted_imageAll Door Triggerposted_image
posted_imageLF LatchBROWN / GRAY(-)IN PASSENGER DOOR SILL HARNESS
posted_imageRF LatchBROWN / BLUE(-)IN PASSENGER DOOR SILL HARNESS
posted_imageTrunk TriggerBROWN / WHITE(-)IN HARNESS FROM TRUNK
posted_imageParking LightsGRAY/WHITE(+)AT VEHICLE LIGHT SWITCH




Posted By: howie ll
Date Posted: October 05, 2009 at 1:10 AM

Somewhere at the rear or under the rear seat is the vacuum control for the locks. You will pick up all the door/trunk and possibly hood switch there, also the lock/unlock wires. Probably blue lock and black unlock, or vice versa.  Extend lock pulse to effect window/roof close. DO NOT UNDER ANY CIRCUMSTANCES Pick up any wiring from the ignition switch before testing with a DMM. It's safer and easier to run out to an engine bay fuse box and pick these and the lights up from the fuse box/ processor outputs. Don't worry about dome supervision, the dome lights will come on with unlock. If not use driver's door lead.

Sorry I can't be more precise but I've only done audio and phone work on post 2000 models. The cost of making mistakes is too high.






Print Page | Close Window