2006 2007 hhr wiring guides
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117206
Printed Date: June 07, 2024 at 6:43 PM
Topic: 2006 2007 hhr wiring guides
Posted By: mazda 6t9
Subject: 2006 2007 hhr wiring guides
Date Posted: October 24, 2009 at 11:16 AM
Just looking for the wiring codes for these 2 years of vehicles. I am doing a couple GPS tracking units with door unlock. Thank you.
Replies:
Posted By: mazda 6t9
Date Posted: October 24, 2009 at 11:17 AM
chevorlet of coarse, sorry.
Posted By: chev104275
Date Posted: October 24, 2009 at 11:49 AM
2006 - 2007 HHR
Battery RED / BLACK (50 AMP) (+) AT BCM C3 CONNECTOR PIN D1
Ignition 1 YELLOW (+) IGNITION HARNESS
Door Lock Circuit ONE WIRE RISISTOR BASED
Power Unlock WHITE (-) DRVERS KICK PANEL GROUND THROUGH A 1500 OHM RESISTOR
PowerLock WHITE (-) DRVERS KICK PANEL STRAIGHT GROUND
-------------
If i Can't Install it I Don't need it Joe
Posted By: mazda 6t9
Date Posted: October 24, 2009 at 11:54 AM
How about the starter wire also, thank you again for the info.
Posted By: chev104275
Date Posted: October 24, 2009 at 12:46 PM
Starter 1 YELLOW (-) ECM BLUE CONNECTOR PIN 56 OR PIN 46
THIS VEHICLE STARTS WHEN IGNTION POWER IS APPLIED AND ACCESSORY POWER IS LOST,
no problem
-------------
If i Can't Install it I Don't need it Joe
Posted By: chriswallace187
Date Posted: October 24, 2009 at 6:44 PM
mazda 6t9 -
Can you specify what you need the starter wire for (e.g. remote start, or starter interrupt) - the HHR, along with most other late model GM products, doesn't have a conventional starter wire at the ignition switch, so the interface is a bit different.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
Posted By: mazda 6t9
Date Posted: October 25, 2009 at 7:20 AM
I need it for a starter kill for GPS disable.
Posted By: metz35
Date Posted: October 25, 2009 at 9:07 AM
starter wire is yellow - @ ECM, BLUE Plug, Pin 56 or 46
Posted By: mazda 6t9
Date Posted: October 25, 2009 at 10:07 AM
What color is the ignition wire as well the module requires an ignition source thanks
Posted By: chriswallace187
Date Posted: October 25, 2009 at 12:02 PM
As listed above, the yellow wire in the ignition harness would be an ignition source.
Also I've found there's a thin(maybe 18 ga.) pink wire in the red plug at the BCM which shows ignition voltage whether turned on with the key or the factory remote start.
Additionally, if you don't care about disabling the factory remote start with your starter kill, wire a relay to connect the yellow and brown wires at the ignition switch when the starter kill is active.
-------------
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
|