key override all bypass
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=117722
Printed Date: May 29, 2024 at 12:25 AM
Topic: key override all bypass
Posted By: brandenl
Subject: key override all bypass
Date Posted: November 14, 2009 at 10:58 AM
im installing a rs in a 2003 f-150 and i have the key over ride all by pass and i dont know where to find the data in's and out on the truck
-------------
branden
Replies:
Posted By: tommy...
Date Posted: November 14, 2009 at 10:12 PM
What is the model # of the bypass...? Usually the install manual has all the wiring info...The bypass you have does not require a key to be inserted ...right...?
-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
Posted By: tommy...
Date Posted: November 14, 2009 at 10:24 PM
4. WHITE/ lt Green(tx) 3. Gray/Orange(rx) ...Connectors A and C are found 8 inches lower on PATS harness. You have the C connector...Pins 3-4 are the tx and rx wires you need... You can look at this install guide if you are still confused... https://www.idatalink.com/documents/install-guides Look at this model's manual ...ADS-TBSL-FM...6th up from the bottom or so...Might not be the same bypass...but it has all the trucks wiring and locations...
-------------
M.E.C.P & First-Class
Go slow and drink lots of water...Procrastinators' Unite...Tomorrow!
Posted By: Velocity Motors
Date Posted: November 15, 2009 at 8:46 AM
On the 03's there is a 4 pin connector to the right of the steering column. I think it's GRAY in color and if you unplug this and thrun the key to the ON position, your theft light will blink fast, this will be the correct connector. If your theft light doesn't blink fast after unplugging it, then it is not the right harness. In the harness you will find the wires listed above by tommy..
-------------
Jeff
Velocity Custom Home Theater
Mobile Audio/Video Specialist
Morden, Manitoba CANADA
Posted By: dswift
Date Posted: November 16, 2009 at 5:04 PM
Get your install guide from www.ifar.ca That is easy as 123. In= RX out=TX FYI ------------- "dont ground out!"
Posted By: brandenl
Date Posted: November 21, 2009 at 8:31 PM
i got it all done it was a green connector and the problem i had was with the negative while running thanks anyway
-------------
branden
|