viper 5901 factory alarm disarm problem
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118435
Printed Date: May 16, 2024 at 7:17 AM
Topic: viper 5901 factory alarm disarm problem
Posted By: coloradobrad
Subject: viper 5901 factory alarm disarm problem
Date Posted: December 11, 2009 at 4:19 PM
A local installer installed a Viper 5901 in my 2009 Dodge Ram 3500 Diesel.
It works perfectly except that the remote start triggers the factory alarm for a second or two (horn). We think it's a timing issue between the factory disarm signal and the remote start signal.
Any ideas?
Thanks!
Replies:
Posted By: shaggy12volt
Date Posted: December 12, 2009 at 1:12 PM
did you send the oem disarm wire from the remote start to the violet / lt.blue (-) throu a 480ohm resister it is in the drivers kick panel
-------------
The Shagmaster
1999 Chevy Suburban 15" lift sittn on 22's sets 7'5"
1992 Chevy Astro Van all Bagged out Dubbed THE SUICIDER
Installing for over 18 years Looking for empolyment NOW send PM for resum
Posted By: coloradobrad
Date Posted: December 14, 2009 at 2:38 PM
I believe that's what the installer did.
He called DEI. They told him to send the disarm signal to the door unlock. This disarms the OEM alarm faster. That works (factory alarm not triggered during remote start) but now the doors are unlocked during the 15 sec diesel wait-to-start. They are relocked after it starts. During this 15 seconds, if I open the door, the viper alarm does NOT go off. This worries me. What gives?
|