viper 5002 in 02 civic remote ent?
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118566
Printed Date: May 14, 2024 at 5:58 PM
Topic: viper 5002 in 02 civic remote ent?
Posted By: danlins
Subject: viper 5002 in 02 civic remote ent?
Date Posted: December 15, 2009 at 8:37 PM
I'm a little confused:
https://www.the12volt.com/installbay/forum_posts.asp?tid=87504&KW=02+civic says no diodes required for lock or unlock,
while
https://www.the12volt.com/installbay/forum_posts.asp?tid=68717&KW=02+civic says diodes are required.
Are the isolating diodes only required for the trigger and not for the door (-) lock/unlock wires? That's how it looks, reading these posts, but looks can be deceiving....
Thanks,
del
-------------
Dan L
Replies:
Posted By: 05gt
Date Posted: December 15, 2009 at 10:03 PM
in this car the diodes are only need for the doorpin wires, NOT for lock and unlock
Posted By: danlins
Date Posted: December 18, 2009 at 12:25 PM
In the help at https://www.the12volt.com/installbay/forum_posts.asp?tid=87504&KW=02+civic, Mobilecustoms said
"POWER LOCK WHITE/ BLUE (TYPE B) IN GRAY PLUG, ABOVE DRIVERS KICK PANEL
POWER UNLOCK WHITE/ GREEN (TYPE B) IN GRAY PLUG, ABOVE DRIVERS KICK PANEL ..if your unit has straight neg lock outputs hook directly to it
no diodes needed"
I'm wading through the install right now, very straightforward except for this isolation question on the power lock/unlock. Thanks
-------------
Dan L
Posted By: kgerry
Date Posted: December 18, 2009 at 3:23 PM
you should be fine hooking direct... i never isolate the doorlock output anf have never run into any issues.... just wire it as negative....
-------------
Kevin Gerry
Certified Electronics Technician
MECP First Class Installer
Owner/Installer
Classic Car Audio
since 1979
Posted By: danlins
Date Posted: December 18, 2009 at 4:16 PM
Kevin,
Everything appears to be working fine. Thanks for your input.
Dan
-------------
Dan L
|