2006 gmc canyon

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=118812
Printed Date: June 09, 2024 at 6:32 PM

Topic: 2006 gmc canyon

Posted By: doug.b
Subject: 2006 gmc canyon
Date Posted: December 25, 2009 at 9:59 PM

i installed a prostart 3310 with a IDatalink ADS DLSL GM Bypass connected through R232 data port on the remote start. When I try to start the truck it powers up everything but it wont try to crank the engine also the door locks wont work . I have followed the program procedure for the bypass and tried another bypass and it wont wok. any suggestions

-------------
doug.b

Replies:

Posted By: tedmond
Date Posted: December 25, 2009 at 10:37 PM

disconnect the rs232 data port and connect everything wire-to-wire. On that note, the default of the data port is for xpresskits, not ads modules or fortin. if you want, you need to go into programming and change it.

-------------
Ted
2nd Year Tier 1 Medical School
Still installing as a hobby...pays for groceries
Compustar Expert

Posted By: 05gt
Date Posted: December 26, 2009 at 9:55 PM

what firmware is on the bypass

how did you program the bypass

when you program for the GM cars you need to follow very carefully and do exactly what it says, if it doesn't work the first time try again it may take a few times to get it right

Print Page | Close Window