Print Page | Close Window

push button door popper

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=121321
Printed Date: October 31, 2024 at 5:55 PM


Topic: push button door popper

Posted By: mightymouse35
Subject: push button door popper
Date Posted: April 13, 2010 at 2:33 PM

hey guys i have 94 chevy truck, i have shaved door handles and a door popper kit all ready installed. im in the process of building new interior door panels. i want to add a switch in side to pop the doors open. can i just use a momentary switch inline w/ the solenoids. as of now they operate thru a 2button remote. thanks n advance guys.



Replies:

Posted By: Mark Mizenko
Date Posted: April 13, 2010 at 9:03 PM

No, you need to wire the switch to a relay to send the power to the door popper.  On the relay there are numbers on the terminals.

constant +12V to terminals 85 and 30

terminal 87 to the +12 on your door popper

The on your pushbutton switch, one side to ground, and the other side to 86 on the relay

when you push the button it will send a ground to the relay coil, it will energize, sending the +12 volts to the popper.  You should put a fuse at your +12volt source





Posted By: mightymouse35
Date Posted: April 15, 2010 at 1:05 PM
thanks for the speedy reply. i will try this. thanks again





Print Page | Close Window