python 991/viper 5901 remote warnings
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124287
Printed Date: May 29, 2024 at 6:44 AM
Topic: python 991/viper 5901 remote warnings
Posted By: joeyalex
Subject: python 991/viper 5901 remote warnings
Date Posted: November 05, 2010 at 1:57 AM
I recently installed a Python 991 alarm/RS system into my 2006 Mustang. Everything works fine as far as the alarm goes, but I have a question about the remote.
On some of the older Viper systems I have seen (5000 in particular) the remote will "retain" a warning/alarm page alert on the screen until a button is pushed.
This new system, however, only shows the page alert on the remote for a little bit of time and then returns to the status screen like nothing happened. Is there a way to change this behavior? Do the Viper branded remotes do this as well? I'd even be willing to go with a 5902 remote if it will fix this behavior.
Any thoughts?
Replies:
Posted By: Thack79
Date Posted: November 05, 2010 at 8:43 AM
As far as i know it wont stay on the screen. if another alarm goes off (and the iginition wire hasnt been switched) it will reappear and when you disarm with will beap a certain number of times reminding you that it was tripped.
|