2000 durango data wire o

Hello everyone,

a quick history of this install,
i installed a compustar one-way on my 2000 durango it lists it as requireing a bypass, my keys arent chipped they are the thin black ones. But in the event it was i used a Fortin CHRDAA which does transponder, door locks and factory security bypass. After the install i test the vehicle with out the bypass and it remotely starts, which confirms it dosnt have a transponder but i do have to bypass the factory security.


Now when i go to wire the data wire from the bypass to the car, it says to use a lt.green /orange wire which i cannot find on the OBD2 plug.

is there somewhere else i need to locate this wire?

Thank-you in advance for the help

anyone have a clue where i can find this wire? or do i need to bypass it manually with resistors?

thanks

i see that fortin's website lists this module as being compatible with that vehicle, but i don't think it can actually do that for you. the reason i say this is because neither xpresskit or idatalink (fortin's competitors) list any modules for that year durango.

i would just use relays with a negative trigger with the follow resistance -

Lock/arm - 647 ohm
Unlock/disarm - 1562 ohm

you'll also need to hookup fact. alarm disarm to your unlock trigger wire and set unlock to double pulse.

good luck!

which harness can i find the disarm wire? is it with the lock wires as i have those, cant quite find the disarm wire.

thank you very much