2003 dakota remote start troubleshooting
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=124784
Printed Date: May 29, 2024 at 4:38 AM
Topic: 2003 dakota remote start troubleshooting
Posted By: schroedc
Subject: 2003 dakota remote start troubleshooting
Date Posted: December 02, 2010 at 7:52 PM
I have installed an audiovox remote start unit in my 2003 dakota with the 4.7, I have a decent tach signal coming out but the device will not successfully learn the tach signal so I can move on to actually using the remote start to finish testing the install. Has anyone else run into this and have any suggestions?
Replies:
Posted By: blanx218
Date Posted: December 02, 2010 at 9:13 PM
where did you connect your tach wire? you should connected to the wire of one of the ignition coils that is not GREEN/ orange. have you measured the voltage from the tach wire? you should have about 5-8 volts AC when running and 0 VAC when the truck is off. if your having trouble with tach signal programming you can try programming it for voltage sense.
Posted By: phil6710
Date Posted: December 02, 2010 at 9:47 PM
can you program the starter for a tachless install?
-------------
Solartech Window Tinting and Electronics,contract installer
|