2010 ford edge tach wire
Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126056
Printed Date: May 03, 2024 at 3:51 AM
Topic: 2010 ford edge tach wire
Posted By: gregbbb
Subject: 2010 ford edge tach wire
Date Posted: February 07, 2011 at 11:38 AM
I am installing a viper 5901 in a 2010 ford edge. I was going to use the fuel injector wire for the tach does anyone know what wire to use?
I have the info from this site and one from wire color one says use the blue and the other says use the green.
Thanks!!
Replies:
Posted By: howie ll
Date Posted: February 07, 2011 at 11:49 AM
Each injector will have 2 wires. One colour is common to all the injectors, the other wire is a different colour for each injector.
Use any of the different colour wires.
And TEST set DMM to 20VAC. With the engine running, black probe to ground, red to wire, you should get 3-6 VAC.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: gregbbb
Date Posted: February 07, 2011 at 6:16 PM
Hey howie
Thanks for the tach info and if you dont mind me asking you one more thing?
On the ford edge what would you use for the door triggers and domelight suppervision one diagram I have from color wire says
use all four door triggers (-) and use diode's they show cutting and using like 8 diodes or the diagram here on this site says use the (+) dome light door for the door triggers if thats the case can you use the domelight suppervision wire on ether one of the ways I mentioned?
Thanks!!
Posted By: dasbogie
Date Posted: February 07, 2011 at 7:38 PM
use the + dome light, you may have to program door error chirp to off
-------------
Advanced
Posted By: gregbbb
Date Posted: February 07, 2011 at 11:57 PM
What wire should I use for the domelight suppervision?
Posted By: howie ll
Date Posted: February 08, 2011 at 3:03 AM
Purple at the puddle lamp to the purple of your 5901.
The other info you have is out of date you would also have to programme your door triggers to NC or use 4 x DTIMazda units.
-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.
Posted By: gregbbb
Date Posted: February 08, 2011 at 9:50 AM
Ok then use that same wire for domelight suppervision to turn on the dome lights when unlocking.
|