Print Page | Close Window

dei 529t resistance change

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=126122
Printed Date: June 09, 2024 at 6:51 AM


Topic: dei 529t resistance change

Posted By: chrizzerz
Subject: dei 529t resistance change
Date Posted: February 11, 2011 at 10:30 PM

Hi everyone, I have a 529t installed on my truck and ccasionally the windows don't roll up all the way.  I know the 530t has dipswitches to change the resistance it stops at, buy my 529t doesn't.  I've heard that you can open the unit up, and solder in a resistor of your own to change the setting though.  Is this possible, and if so how is it done?



Replies:

Posted By: howie ll
Date Posted: February 12, 2011 at 2:41 AM
Probably a lot easier to check that the window mech moves freely and occasionally spay the channels with WD 40.

-------------
Amateurs assume, don't test and have problems; pros test first. I am not a free install service.
Read the installation manual, do a search here or online for your vehicle wiring before posting.


Print Page | Close Window