2010 suburban remote start

Printed From: the12volt.com
Forum Name: Car Security and Convenience
Forum Discription: Car Alarms, Keyless Entries, Remote Starters, Immobilizer Bypasses, Sensors, Door Locks, Window Modules, Heated Mirrors, Heated Seats, etc.
URL: https://www.the12volt.com/installbay/forum_posts.asp?tid=128157
Printed Date: May 23, 2024 at 4:45 AM

Topic: 2010 suburban remote start

Posted By: paul h
Subject: 2010 suburban remote start
Date Posted: August 06, 2011 at 2:33 PM

Got a 2010 Suburban and looking to put a RS on it. Can't seem to figure out the right module.

Fortins site shows the CAN-SL2 will work by itself (I think) but also shows the EVO-ALL, EVO-CAN & CAN-SL-PL but says these 3 have to be teamed with the TB-GM2 module.

Can anybody confirm what the best route is or would be for this? Its a basic subruban but would like to use a the feature to pop the rear gate as the factory remote does now...but the factory start stuff is crap.

Thanks in advance for the help!!

Replies:

Posted By: tonanzith
Date Posted: August 06, 2011 at 10:05 PM

Go to www.xpresskit.com

You should use Directeds DBALL

-------------
Gary Sather

Posted By: paul h
Date Posted: August 08, 2011 at 5:08 PM

The DB-ALL would be ok too....

Anyone here sell them or recommend best place to get one? It would be SOO much easier to get one already programed rather than me buy another programmer I'm stuck with for 1 module....

Any other ideas? Thanks

Posted By: tonanzith
Date Posted: August 08, 2011 at 5:14 PM

th db all should come flashed with the correct firmware you just need to program it to the vehicles key/immobilizer system which needs no extra parts. Programming instructions come with it and you could pick one up at your local car stereo shop or best buy or online from xpresskit.com

-------------
Gary Sather